Abstract:Power consumption and scaling the performance and quantity of electrical interconnects for data traffic inside boards and backplanes are one of the critical barriers envisaged in next‐generation Data Center (DC) and High‐Performance Computing (HPC) applications. In this paper, we report developments of electro-optical PCBs (EO-PCB) with embedded polymer waveguide layers. We show results for fabricating realistic product emulator test vehicles that comprise of reasonable form factor PCBs with optical and electrical layers. The optical layer comprise of multiple waveguides exhibiting a full range of geometric configurations required to meet practical optical routing functions. Test patterns include varied cross-sectional sizes, 90° bends of varying radii (40mm – 2mm), cascaded bends with varying radii, waveguide crossings with varied crossing angles (90° - 20°), splitters, tapered waveguides and waveguide interconnect to midboard interface slots. Moreover, results for fabricating electrical interconnect structures (e.g. tracing layers, vias, plated vias) top/bottom and through optical layers in OE-PCB stack are shown. The purpose of the complex routed copper layers is to enable the crucial demonstration of the fabrication and thermal robustness challenges inherent to electro-optical PCBs with optical layers. Process compatibility with accepted practices and challenges in production scale up for high volumes are key concerns to meet the yield target and cost efficiency. Results include waveguide characterization, waveguide transmission loss, misalignment tolerance, and effect of lamination. Moreover, we show results on waveguide termination by in-plane edge connector and with 90° out-of-plane couplers.

Design and implementation of embedded Linux-based PCE hardware

Implementation of PCE-based Management and Control Plane for Heterogeneous Optical Networks

An Optical Network with Distributed PCEs and Its Performance

Design of IPPBX based on embedded system

Design and Implementation of Application Specific Integrated Circuit for CESoP

Implementation of Segmented Protection and Restoration in PCE-based Multi-Domain Heterogeneous Optical Networks

IMPLEMENTION OF HIGH SPEED DATA TRANSPORT OF EMBEDDED HARDWARE PLATFORM SYSTEM

A Distributed Stateful PCE-based Architecture for Providing End-to-end Connections in Multi-Domain Multi-Vendor Optical Networks.

Implementation of Access Controller for Ethernet Passive Optical Network

Realization of High-speed Data Fibre-optical Transmission Based on cPCI Bus

Development of Electro-Optical Pcbs with Embedded Waveguides for Data Center and High Performance Computing Applications

Design of High-speed Data Transmission System Based on cPCI Bus

Interoperation of 400GBASE-LR8 Physical Interfaces Using CFP8 Pluggable Modules

Design and Realization of Embedded Internet-connected Platform

Design and Implementation of Aggregation Platform for Extended Ethernet Transport and Services

Design of Giga Bit Ethernet Readout Module Based on ZYNQ for HPGe

Dual- Channel High- Speed Data Transmission System of Industrial CT

Hardware Design and Implementation of an PON Based Real-Time Ethernet

Development and implementation of network driver based on embedded WinCE

Development of CPE Based on the PSTN Network

Design And Fpga Implementation Of Olt For Epon