Abstract:Due to the existence of diffraction limit as the basic characteristic of light, the lasing on subwavelength scale cannot be achieved by traditional methods. In order to break this diffraction limit, a stacked structure composed of metal, dielectric layer and semiconductor was designed in this paper to achieve lasing on the deep subwavelength scale and its influence on the propagation mode was discussed. In terms of structural design, we used silver, a metal with low dielectric constant, as the substrate, a 10 nm-thick LiF layer as the dielectric layer, and a ZnO semiconductor nanowire with hexagonal section as the high-dielectric-constant layer. We adopted the finite-difference eigen mode and Finite-Difference Time-Domain (FDTD) method to perform optical simulation of the designed structure. First, by changing the nanowire diameter and using the finite eigen mode, the optical modes in the dielectric layer were analyzed to obtain four mode distributions. Then the effective refractive indexes and losses of the four optical modes at different nanowire diameters were used to calculate the corresponding waveguide propagation distances and lasing threshold gains. Finally, the three-dimensional FDTD method was introduced to simulate the electric field distribution of the four modes during the steady-state laser emissionin of the nanowire. The results showed that there were hybrid plasmonic mode and hybrid electric mode in the dielectric layer between the nanowire and the metal substrate. When the diameter of ZnO nanowire was smaller than 75 nm, there was no effective physical optical mode, that is, both the hybrid plasmonic mode and the hybrid electric mode were cut off. When the nanowire diameter was larger than 75 nm, the hybrid plasmonic mode could effectively exist. The hybrid electric mode did not appear until the nanowire diameter reached 120 nm. Although the hybrid plasmonic mode could be better confined to the dielectric layer, its loss was too large and its propagation distance was relatively small. In addition, the hybrid electric mode traveled a longer distance than hybrid plasmonic mode. At the given diameter of the micron wire (D = 240 mu m), the hybrid electric mode propagated for over 50 mu m. In conclusion, the hybrid leaky mode on the deep subwavelength scale can break the optical diffraction limit and realize lasing.

Ultrafast Plasmonic Lasing from a Metal/semiconductor Interface

Hybrid Photon-Plasmon Nanowire Lasers

All-Inorganic CsPbBr3 Nanowire Based Plasmonic Lasers

Organic-Inorganic Perovskite Plasmonic Nanowire Lasers with A Low Threshold and A Good Thermal Stability

Single-Nanorod Plasmon Nanolaser: A Route Toward A Three-Dimensional Ultraconfined Lasing Mode

Design of an Ultrafast Plasmonic Nanolaser for High-Intensity Broadband Emission Operating at Room Temperature

Nanowire Based Hybrid Plasmonic Structures for Low-Threshold Lasing at the Subwavelength Scale

The Electron–Hole Plasma Contributes to Both Plasmonic and Photonic Lasing from CH3NH3PbBr3 Nanowires at Room Temperature

Dimension-programmable CsPbBr3 Nanowires for Plasmonic Lasing with PDMS Templated Technique

Plasmonic lasing of nanocavity embedding in metallic nanoantenna array.

On‐Chip Monolithically Integrated Ultraviolet Low‐Threshold Plasmonic Metal‒Semiconductor Heterojunction Nanolasers

Ultrafast Laser Manipulation of In‐Lattice Plasmonic Nanoparticles

Two‐Photon Pumped Wavelength‐Tunable Single‐Mode Plasmonic Nanolaser with Ultralow Threshold

Ultra-strong Mode Confinement at Semishell Metal/insulator/semiconductor Interface for Nanolaser

Ultrafast Laser Manipulation of In‐Lattice Plasmonic Nanoparticles (Adv. Sci. 38/2024)

Metallic Nanowire Coupled CsPbBr 3 Quantum Dots Plasmonic Nanolaser

Surface Plasmon Enhanced Strong Exciton-Photon Coupling in Hybrid Inorganic-Organic Perovskites Nanowires

Hybrid Plasmonic Leaky-Mode Lasing on Subwavelength Scale

Plasmonic Nanolaser Using Epitaxially Grown Silver Film

Surface Plasmon Enhanced Strong Exciton-Photon Coupling in Hybrid Inorganic-Organic Perovskite Nanowires

Low-threshold upconversion plasmonic lasers based on CsPbBr3 nanoplates