Abstract:Atomic layer deposition (ALD) of Al2O3 using trimethylaluminum (TMA) and water on Pd nanoparticles (NPs) was studied by combining in situ quartz crystal microbalance (QCM) measurements, in situ quadrupole mass spectrometry (QMS), and transmission electron microscopy (TEM) with density functional theory (DFT) calculations. TEM images of the ALD Al2O3 overcoated Pd showed conformal Al2O3 films on the Pd NPs as expected for ALD. However, hydrogen detected by in situ QMS during the water pulses suggested that the ALD Al2O3 films on the Pd NPs were porous rather than being continuous coatings. Additional in situ QCM and QMS measurements indicated that Al2O3 ALD on Pd NPs proceeds by a self-poisoning, self-cleaning process. To evaluate this possibility, DFT calculations were performed on Pd(111) and Pd(211) as idealized Pd NP surfaces. These calculations determined that the TMA and water reactions are thermodynamically favored on the stepped Pd(211) surface, consistent with previous observations. Furthermore, the DFT studies identified methylaluminum (AlCH3*, where the asterisk designates a surface species) as the most stable intermediate on Pd surfaces following the TMA exposures, and that AlCH3* transforms into Al(OH)(3)* species during the subsequent water pulse. The gas phase products observed using in situ QMS support this TMA dissociation/hydration mechanism. Taken together, the DFT and experimental results suggest a process in which the Pd surface becomes poisoned by adsorbed CH3* species during the TMA exposures that prevent the formation of a complete monolayer of adsorbed Al species. During the subsequent H2O exposures, the Pd surface is cleaned of CH3* species, and the net result is a porous Al2O3 film. This porous structure can retain the catalytic activity of the Pd NPs by providing reagent gases with access to the Pd surface sites, suggesting a promising route to stabilize active Pd catalysts.

Modification of the aluminum surface by palladium nanoparticles by galvanic replacement for electrocatalytic CO2 reduction in DMF medium

Carbon-supported PdM (M = Au and Sn) Nanocatalysts for the Electrooxidation of Ethanol in High Ph Media

Highly Active Nanoporous Pt-based Alloy As Anode and Cathode Catalyst for Direct Methanol Fuel Cells

A Gold–Palladium Nanoparticle Alloy Catalyst for CO Production from CO2 Electroreduction

Porous Alumina Protective Coatings on Palladium Nanoparticles by Self-Poisoned Atomic Layer Deposition

Fabrication, microstructure and electrocatalytic property of novel nanoporous palladium composites

High catalytic activity of ultrafine nanoporous palladium for electro-oxidation of methanol, ethanol, and formic acid

Stabilization of Pd0 by Cu Alloying: Theory‐Guided Design of Pd3Cu Electrocatalyst for Anodic Methanol Carbonylation

Nanoporous Palladium Synthesised by Dealloying Al72Pd20Mn8 Quasicrystal for Electrochemical Applications

Surface Noble Metal Modified PdM/C (M = Ru, Pt, Au) As Anode Catalysts for Direct Ethanol Fuel Cells

Mesoporous PdAg Nanospheres for Stable Electrochemical CO2 Reduction to Formate

Nanoporous Palladium Fabricated from an Amorphous Pd42.5Cu30Ni7.5P20 Precursor and Its Ethanol Electro-Oxidation Performance

3D-nanoarchitectured Pd/Ni catalysts prepared by atomic layer deposition for the electrooxidation of formic acid

Preparation of palladium-based catalyst by plasma-assisted atomic layer deposition and its applications in CO2 hydrogenation reduction

Pre-deposited Co nanofilms promoting high alloying degree of Pd Au nanoparticles as electrocatalysts in alkaline media

Two-Dimensional Palladium–Copper Alloy Nanodendrites for Highly Stable and Selective Electrochemical Formate Production

Electrochemical Behavior of Nanostructured Fe-Pd Alloy During Electrodeposition on Different Substrates

Enhancing the Electrocatalytic Activity of Pd/M (M = Ni, Mn) Nanoparticles for the Oxygen Reduction Reaction in Alkaline Media through Electrochemical Dealloying

Electrochemical Fabrication and Reactivation of Nanoporous Gold with Abundant Surface Steps for CO 2 Reduction

An Improved Galvanic Replacement Deposition Method for Synthesis of Compact Palladium Coatings on Copper Substrates

Phosphorous incorporation into palladium tin nanoparticles for the electrocatalytic formate oxidation reaction