A Cost-Effective Electro-Fenton Process with Graphite Felt Electrode Aeration for Degradation of Dimethyl Phthalate: Enhanced Generation of H2O2 and Iron Recycling That Simultaneously Regenerates the Electrode

Dong Li,Tong Zheng,Yulei Liu,Ding Hou,Haiyang He,Haoran Song,Jiaming Zhang,Shiqi Tian,Wei Zhang,Lu Wang,Jun Ma

DOI: https://doi.org/10.1016/j.cej.2020.125033

IF: 15.1

2020-01-01

Chemical Engineering Journal

Abstract:A graphite felt electrode with electrode aeration (GF-EA) was used for the Electro-Fenton treatment of dimethyl phthalate (DMP) wastewater. At pH 3.0, removal efficiencies of 200 mg/L DMP and solution TOC by EA were 50.0% and 55.4% higher than solution aeration (SA), respectively. At pH 4.0 and 5.5, EA showed 36.4–56.1% and 9.4–35.7% higher removal for 20–50 mg/L DMP and TOC than SA, respectively. High effective degradation performance of EA was attributed to the enhanced mass transfer of O2 and the solution, which provided the sufficient active area for H2O2 electro-generation and promoted the Fe3+/Fe2+ cycling, thus increasing the OH content. Using EA, GF could collect iron sludge at low O2 flux, and then strip it for reuse at large air flux. This process regenerated GF electrode and elided the disposal of iron sludge. By supplementing one-fifth of the original FeSO4 dosage, the operation costs of the iron-sludge-stripping EA system were 35% and 27% of those in SA system for the same removal of 200 mg/L and 20 mg/L DMP, respectively. During long-term use, DMP degradation performance of EA gradually improved due to the increased hydrophilic property and oxygen-containing functional groups, while the decreased DMP removal with SA was ascribed to the electrode poisoning caused by iron sludge deposition.