Abstract:Sintering behaviour of ashes from combustion of coal and biomass blends was experimentally investigated with a focus on the effect of ash preparation method. Blends of a Chinese anthracite, Jincheng coal, and two biomass materials, a wheat straw and a pine sawdust, respectively, were subjected to three different ash preparation procedures, namely, a low temperature oxygen plasma ashing device operating at ca 150 degrees C, combustion in a Muffle furnace at 815 degrees C and in a drop tube furnace at 1500 degrees C. The resulting ash samples were then subjected to the sintering temperature measurement using a pressure-drop sintering device, morphological and mineralogical characterisation using scanning electron microscope (SEM) fitted with X-ray energy dispersive spectroscopy (EDS) and X-ray diffractometry analyser (XRD), respectively. For the same coal and biomass blends but different ash preparation methods, the sintering temperatures were always the lowest for the ash samples from the plasma ashing device and the highest from drop tube furnace. SEM imaging showed that the texture of ash samples from the plasma ashing device was irregular, loose and more fibrous, indicating little interactions among the different mineral and inorganic constituents in the individual fuels. The muffle furnace and drop tube furnace ashes were denser and more uniform in shape as the mineral matter and inorganics became fused together. In addition, the drop tube furnace ashes were mostly in spherical-shape, indicating ash melting had occurred during combustion. The XRD analysis revealed that different minerals were present in the ash samples due to different ash preparation temperatures, with high temperature minerals present in the drop tube furnace ash. Biomass addition in the blends lowered the sintering temperature of corresponding ash; the higher the proportion of biomass in the blend, the lower the ash sintering temperature regardless the ashing method. At the same biomass addition ratio, the ash sintering temperature of the blend with the wheat straw addition was lower than that with the pine sawdust addition, because the wheat straw had a higher K and Cl content but lower Ca than the pine sawdust. The EDS and XRD analyses confirmed that the ashes of coal/wheat straw blends contained more K-bearing minerals, while the ashes of the coal/pine sawdust contained more Ca and K-bearing minerals. Both Ca and K-bearing minerals reacted with other minerals in the ash to form low temperature eutectics, leading to the reduction of sintering temperatures of the coal and biomass blends. However, the melting points of the K-containing minerals are higher than the Ca-containing minerals, therefore, the sintering temperatures of ash with the wheat straw addition were lower than those with the pine sawdust addition. (C) 2016 Elsevier Ltd. All rights reserved.

Effects of Hemicellulose, Cellulose and Lignin on the Ignition Behaviors of Biomass in a Drop Tube Furnace

Effects of cellulose, hemicellulose, and lignin on the combustion behaviours of biomass under various oxygen concentrations

Experimental Study on Pyrolysis and Combustion Properties of Biomass Briquette.

Investigations Into The Effect Of Cellulose And Lignin On The Co-Combustion Characteristics Of Coal And Biomass

Influence of the synergistic effects and potassium on the combustion behaviors of biomass under high heating rate

Combustion Characteristics of Three Biomass Components in the O2/CO2 Atmosphere

Investigations into the Ignition Behaviors of Pulverized Coals and Coal Blends in a Drop Tube Furnace Using Flame Monitoring Techniques

THE EFFECT OF CELLULOSE AND LIGNIN ON THE CO-COMBUSTION BEHAVIOR OF BIOMASS AND COAL

Influence of the synergistic effects between coal and hemicellulose/cellulose/lignin on the co-combustion of coal and lignocellulosic biomass

Nonisothermal Thermogravimetric Kinetic Investigations On Combustion Behaviors Of Concomitant Biomass From Urban Plants

Effect of cellulose, hemicellulose and lignin contents on pyrolysis and combustion of natural fibers

Effect of porosity on ignition and burning behavior of cellulose materials

Computational study of the effects of density, fuel content, and moisture content on smoldering propagation of cellulose and hemicellulose mixtures

Ignition Characteristic of Blended Coal in a Drop-Tube Furnace

Effect of Ash Preparation Method on the Sintering Characteristics of Ashes from Combustion of Coal and Biomass Blends

Ignition and combustion of single pulverized biomass and coal particles in N2/O2 and CO2/O2 environments

Kinetic Analysis on Non-isothermal Combustion of Several Urban Biomass Fuels

Visualization of Combustion Phases of Biomass Particles: Effects of Fuel Properties

Fouling and Slagging Characteristics During Co-Combustion of Coal and Biomass

Effect of Turbulent Mixing on Combustion Behaviours of a Single Biomass Pellet

Cellulose, Xylan and Lignin Interactions During Pyrolysis of Lignocellulosic Biomass