Conversion of Waste Lignocellulose to Furfural Using Sulfonated Carbon Microspheres As Catalyst

Xiaoyun Li,Xuebin Lu,Min Liang,Rui Xu,Zhihao Yu,Bingyu Duan,Lefu Lu,Chuanling Si

DOI: https://doi.org/10.1016/j.wasman.2020.04.039

IF: 8.816

2020-01-01

Waste Management

Abstract:Catalytic conversion of xylose and the hemicellulose fraction of waste biomass to furfural is important for the valorization of waste lignocellulose. Here, a clean and efficient catalytic system consisting of sulfonated carbon microspheres catalysts and c-valerolactone was developed for the upgrading of xylose and waste lignocellulose to the furfural in one-pot. Sulfonated carbon microspheres (C-Co-S) with Bronsted and Lewis acid sites were prepared to yield furfural. The mesoporous structures were facilitated by introduction of Co element in xylose hydrothermal process, and the density of Bronsted acid sites were improved by the sulfonation. The furfural yield from xylose reached 75.12% using C-Co-S as catalyst at 170 degrees C for 30 min in a gamma-valerolactone/water (17/3 v/v) solvent. As typical Bronsted acid, the -SO3H groups on the surface of C-Co-S catalyst is essential for catalytic dehydration xylose to furfural. Additionally, the mesoporous structures of C-Co-S improved the mass transfer in the furfural production process. The catalytic system was applied in the conversion of real biomass (including corncob, corn straw and Eucalyptus sawdust) to evaluate the possibility of application. These three biomass species all reached excellent furfural yields, which were more than 70%. This work provided a catalytic strategy for effective conversion of xylose and biomass to furfural. (C) 2020 Elsevier Ltd. All rights reserved.