Comparison of Fermentative Hydrogen Production from Molasses in Two Continuous Stirred Tank Reactors: CSTR Versus ACR

Qing Fu,Sheng Chang,Yue-Ting Fan,Jian-Zheng Li
DOI: https://doi.org/10.5004/dwt.2020.25203
IF: 1.1
2020-01-01
Desalination and Water Treatment
Abstract:The performance of fermentative hydrogen production bioreactors at different organic load rates (OLRs) in both a continuous stirred tank reactor with an inner gas-liquid-solid three-phase separator installed (ICSTR) and anaerobic contact reactor (ACR) was investigated. Five OLRs were examined, ranging from 12 to 36 g COD/L-d, with influent diluted molasses concentrations ranging from 4,000 to 8,000 mg COD/L and hydraulic retention time (HRT) ranging from 8 to 4 h. For the ICSTR, when the OLR was below 24 g COD/L-d, the hydrogen yield maintained at about 1.74 mol/mol glucose-converted, while the system failed to operate when the chemical oxygen demand (COD) was increased to 8,000 mg/L or the HRT was shorted to 4 h, this is because of t the low buffer ability and biomass washing out. However, for the ACR system, hydrogen production rate (HPR) and hydrogen yield increased linearly along with the increasing of OLR due to the elevating enhancement of biomass. The HPR and hydrogen yield peaked at 3.77 L/L-d and 1.83 mol/mol glucose-converted under the OLR of 36 g COD/L-d, respectively. The results showed that ethanol and acetate were predominated soluble products. The molar hydrogen yield was correlated linearly with the ethanol-acetate ratios, indicating hydrogen consumption by homoacetogenic bacteria, which significantly affected the hydrogen production.
What problem does this paper attempt to address?