Abstract:During a core meltdown accident, the significant decay heat within the corium pool will continually impose thermal load on the vessel wall and challenge the integrity of reactor pressure vessel (RPV). External Reactor Vessel Cooling (ERVC) is considered to be an effective strategy to reduce the potential of vessel failure. After long-term cooling, the initially uniform melt pool can reach a final steady state with stable two-layer or three-layer configuration. Based on the COPRA facility, a series of tests were performed to study the natural convection heat transfer phenomenon of stratified corium pools. The test section was a full-scale 2D slice, simulating the hemispherical lower head of the HPR1000 reactor design. Direct electrical heating was applied in the lower part of vessel to simulate the homogenously heated ceramic pool, while no heat was generated in the upper part to model the metallic layer. A binary mixture of 20 mol% NaNO3-80 mol% KNO3 was selected as simulant material due to the similar phase-change characteristics with the prototypical melt. During the experiment, effects of heating power, top boundary condition, corium pool height, decay heat distribution and simulant material on corium pool heat transfer behavior were analyzed. The results implied that the top cooling and decay heat distribution slightly influenced the temperature and heat flux of ceramic pool, but strongly impacted the characteristics of metallic layer. The comparison between the dimensionless parameters of water tests and salt tests also demonstrated the key role of simulant material. Furthermore, the downward heat transfer Nu(dn) and the upward heat transfer Nu, obtained from COPRA two-layer experiment were in accordance with the previous data or empirical correlations. Note that using the same simulant material for oxide layer and metal layer fails to repeat the boundary conditions in the reactor case, however, the current study pays more attention to the qualitative analysis of different influence on natural convection heat transfer behavior. More valuable information about the crust characteristics and stratification effect can be obtained by the following CFD simulation of these tests. (C) 2019 Elsevier Ltd. All rights reserved.

Parameter Analysis of Natural Convection Thermal Characteristics in Internally Heated Pool

CFD Calculation of Natural Convection Heat Transmission in a Three-Dimensional Pool with Hemispherical Lower Head

Copra: A Large Scale Experiment on Natural Convection Heat Transfer in Corium Pools with Internal Heating

Experimental Study on Natural Convection Heat Transfer in a Two-Layer Corium Pool Based on COPRA Facility

Direct Numerical Simulations of Pool Boiling Curves Including Heater's Thermal Responses and the Effect of Vapor Phase's Thermal Conductivity

Experimental Study and Model Development for the High-Rayleigh-number Corium Pool with Heat and Mass Transfer

Experimental Research on Heat Transfer Behavior of Large Scale Two-Layer Salt Melt Pool Based on COPRA Facility

Natural convection heat transfer in corium pools: A review work of experimental studies

Experimental Study on Influence of Crust Formation on Heat Transfer Characteristic in Corium Pool

Experimental study on the influence of heating surface inclination angle on heat transfer and CHF performance for pool boiling

Experimental Investigation on Heat Transfer Performance of C-shape Tube Immerged in a Water Pool

COPRA Experiments on Natural Convection Heat Transfer in a Volumetrically Heated Slice Pool with High Rayleigh Numbers

Thermo-hydraulic characteristics of thermal interface induced by natural convection in water tank with internal heat source

Experimental Investigation and Analysis on Temperature Distribution in Water Pool of External Reactor Vessel Cooling System

Performance analysis of natural convection in presence of internal heating, strong turbulence and phase change

Copra experiments on natural convection heat transfer with high rayleigh numbers

Numerical Simulation of Complete Pool Boiling Curves: from Nucleation to Critical Heat Flux Through Transition Boiling to Film Boiling

Investigation on Heat Transfer of In-Tube Supercritical Water Cooling Accompanying Out-Tube Pool Boiling

Dimensional comparable numerical analysis of the thermal stratification in the lead-cooled experimental facility CLEAR-S

The Analysis of Residual Heat Long Time Cooling about Pool-type Reactor

Mesoscale Simulation of Heater Size and Subcooling Effects on Pool Boiling under Controlled Wall Heat Flux Conditions