Abstract:Hydropower has been the leading renewable source and cheapest ways to generate electrical energy in the world. In recent years, there has been a major upsurge in the hydropower development because of the use of pump as turbine (PAT). However, the operational reliability of a PAT is greatly affected by the unsteady flow fields; therefore, it is important to examine the unsteady flow behavior which can be used as a reference to reduce the noise, vibration, and cavitation performance for centrifugal pumps working as turbines. Thus, the objective of this study was to evaluate the unsteady flow fields by analyzing the distribution of the pressure pulsations using both numerical and experimental measurements in a PAT operating in pump mode. Firstly, the three‐dimensional (3D) unsteady flow equations were solved using SST <i>k‐</i>ω turbulence model during the numerical calculations. Secondly, the numerical results of the hydraulic pump performance were validated by the experimental measurements for numerical accuracy. Lastly, pressure transducers are positioned at certain monitoring points to measure the pressure in the PAT investigated. The numerical and experimental results show that the main frequency of the pressure pulsation is equal to the blade frequency, and as it deviates from the design operating condition, the magnitude of pressure pulsation intensifies. Furthermore, the impeller eye marked the lowest pressure coefficients especially at the design condition and makes it highly susceptible to cavitation. High pressure coefficients were obviously seen at the pressure side on the blade surface closer to the trailing edge at all studied operating conditions. Meanwhile, the rotor‐stator interaction generated the highest pressure pulsation distribution at the volute tongue. Thus, modification of the volute tongue is an optimal approach of reducing the pressure pulsation intensity in the volute and pump as a whole.

Pressure and Flow Characteristics of Two Dimensional (2d) Piston Water Hydraulic Pump

Pressure and Flow Characteristic Modeling of Water Hydraulic Axial Piston Pump Based on Variable Fluid Properties

Modelling and Experiment Study on Fluid Character of Axial Piston Pump

Experimental and numerical investigations on pressure pulsation in a pump mode operation of a pump as turbine

Flow characteristics simulation and low-noise design of fuel piston pump

Numerical Simulation of Cavitating Flow in Water Hydraulic Axial Piston Pump

Experimental Research on Performance of Water Hydraulic Internal Gear Pump

Model and Simulation on Flow and Pressure Characteristics of Axial Piston Pump for Seawater Desalination

Analysis and Experimental Research on Efficiency Characteristics of a Deep-Sea Hydraulic Power Source

Characteristics of Volumetric Losses and Efficiency of Axial Piston Pump with Respect to Displacement Conditions

Design strategy and performance evaluation of novel miniature two-dimensional (2D) piston pump with a dual stacking mechanism

Outlet Pressure and Flow Characteristics of a New Two-Dimensional Piston Pump with an Overlapped Distributor

Modeling and Analysis of the Churning Losses Characteristics of Swash Plate Axial Piston Pump

Hydraulic Optimization and Loss Analyses of a Low Specific-Speed Centrifugal Pump with Variable-Thickness Blades

Analysis of the Flow Dynamics Characteristics of an Axial Piston Pump Based on the Computational Fluid Dynamics Method

Research on Pressure Pulsation Characteristics of Axial Piston Pump Based on Virtual Prototype

Modeling and Simulation on Axial Piston Pump Based on Virtual Prototype Technology

Design and Characteristic Research on Variable Displacement Mechanism of Two-Dimensional (2D) Bivariable Pump

Distribution characteristics and impact on pump’s efficiency of hydro-mechanical losses of axial piston pump over wide operating ranges

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump

Structural Design of a Cross Wobble Plate Driving Axial Piston Pump Based on ADAMS and AMESim Co-simulation