Abstract:The small scale Organic Rankine Cycle (ORC) using a turbine as expanders is considered as one of the most efficient ways to convert the waste heat energies of automobile engine into electrical energy, in the power range from several kW up to dozens of kW. In general, two important factors must be taken into account when designing the ORC turbine: the real gas effects of the organic fluid and the high expansion ratio presented in the machinery due to thermodynamic and efficiency factors. The characteristic parameters of R245fa have great difference compared with air. When designing an ORC turbine, the initial problem is the influence of the working fluid characteristic parameters on the turbine performance. Similarity analysis method is used to analyze this problem. When using the similarity theory to design two similar operating conditions, gas constant R and dynamic viscosity μ are easy to be taken into account as they have a dimension; specific heat ratio κ is hard to be taken into consideration. In this paper, a high expansion ratio ORC turbine is generated for a small scale ORC system working with the organic fluid R245fa, and the influence of κ on the turbine performance parameters analyzed. Firstly, the turbine geometry is designed in an iterative process using the commercial design tool Concepts-NREC Rital program, and the designed operating condition is determined. Secondly, the similarity criterion numbers are deduced with no consideration of the specific heat ratio κ, and the similar operating condition is calculated by the deduced similarity criterion numbers. The results achieved by the one-dimensional design software Rital shows that the deviation of similarity criterion numbers is small, which indicates that the two operating conditions are similar. Then, to verify the conclusion above, the flow field simulation using one channel model is conducted based on the R245fa operating condition and air operating condition using the computational fluid dynamics (CFD) code NUMECA-FineTurbo. However, deviations of the similarity criterion numbers from the CFD results are more than twice to those from the one-dimensional results. The larger deviation may indicate that the influence of the specific heat ratio κ cannot be ignored. After that, the distributions of the total pressure, total temperature, the relative Ma number and entropy in the nozzle and rotor channel are compared. These results show that except the total temperature the distributions of the other three parameters are very similar. The similar distribution may indicate that the specific heat ratio κ has little influence on the efficiency and expansion ratio, but κ has greater influence on the temperature and output power. All of these conclusions are made according to the simulation results, the accuracy should be verified through the test results.

Preliminary Design and CFD Analysis of a Radial Inflow Turbine and the Turbine Seal for an Organic Rankine Cycle Using Zeotropic Mixture

Cooperative Optimization of System Parameters and Heat Exchanger Structure for Geothermal Organic Rankine Cycle

Simultaneous Optimization for Organic Rankine Cycle Design and Heat Integration

Working Fluid Selection for a Small-Scale Organic Rankine Cycle Recovering Engine Waste Heat

Thermodynamic Analysis and Optimization of Organic Rankine Cycles Based on Radial-Inflow Turbine Design

Analysis of a 1 Kw Organic Rankine Cycle Using a Scroll Expander for Engine Coolant and Exhaust Heat Recovery

Investigation of the Organic Rankine Cycle (ORC) System and the Radial-Inflow Turbine Design

Zeotropic Mixture Active Design Method for Organic Rankine Cycle

Impact of Turbine Characteristics on Low Temperature Organic Rankine Cycles Operating with Zeotropic and Azeotropic Mixtures.

The Influence of Working Fluid Characteristic Parameters on Turbine Performance for the Small Scale ORC System

Numerical simulation and low speed experiment of a low partially admitted rate axial turbine for small scale organic Rankine cycle

Optimal Design and Tip Leakage Flow Characteristics Analysis of Radial Inflow Turbine Used in Organic Rankine and Vapor Compression Refrigeration System

Optimal coupling design for organic Rankine cycle and radial turbine rotor using CFD modeling, machine learning and genetic algorithm

Design and study of Organic Rankine Cycle (ORC) and turbine for ORC

A Novel Analysis Framework for the Organic Rankine Cycle Waste Heat Recovery System: from the Viewpoint of Turbine Design

Thermo-economic design, optimization, and evaluation of a novel zeotropic ORC with mixture composition adjustment during operation

Thermodynamic analysis and optimization of an innovative geothermal-based organic Rankine cycle using zeotropic mixtures for power and hydrogen production

Numerical study of organic Rankine cycle radialinflow turbines for heavy‐duty diesel engine coolant heat recovery

Influence of the Radial-Inflow Turbine Efficiency Prediction on the Design and Analysis of the Organic Rankine Cycle (ORC) System

Performance Prediction and Working Fluid Active Design of Organic Rankine Cycle Based on Molecular Structure

Similarity Based Performance Prediction of Organic Rankine Cycle Turbine Using Air Condition Data