Abstract:Superheated droplets vaporized in a vacuum or vapor chamber was studied using smoothed particle hydrodynamics method.The two-phase fluids of vapor and liquid with a diffused interface were modeled by Navier-Stokes-Korteweg equations,with the van der Waals equation of state.The liquid-vapor separation was processed with different initial temperature and density.Simulation was firstly validated by the proper equilibrium states with analytical data from the binodal line of Maxwell construction,as well as the droplet surface tension compared with experimental and other groups'numerical data in a good agreement.Droplet morphology,density,temperature and entropy increment were then carefully examined during the dynamic process from evaporation to boiling.Four phase transitions patterns were concluded,namely from surface evaporation,internal bubble,fragment and explosion,to flash boiling with increasing equivalent superheat degree that is defined by the non-dimensional superheat temperature over surface tension.Results showed that droplet temperature and density decreased slightly at surface evaporation when equivalent superheat degree was lower than 1/3.Above this criterion,the internal bubble could be sustained.Growth of new liquid nucleates and connected secondary liquid ring were calculated by domain growth theory.We found that droplet continuous to expand at high superheat but withdrawn at equivalent superheat degree equal to or lower than 0.52.At equivalent superheat degree higher than 1,the growth and expansion of droplet resulted in liquid fragment and explosion to many small secondary droplets.Mean mass and diameter of these droplets were found to have power-law dependency on the expansion rate.Finally,fast flash boiling occurred at equivalent superheat degree higher than 3.The vapor pressure in the chamber showed a negative linear correlation between the overpressure and the atmospheric pressure.We also found out that comparing to increase the pressure value,dense gas had better efficiency on retarding the propagation of shock wave.

Vaporization and Particle Formation During Drying of Multisolvent Droplet Without and with Antisolvent-Vapor Infusion

Droplet Evaporation to Boiling in Van Der Waals Fluid

Vapor Transport of a Volatile Solvent for a Multicomponent Aerosol Droplet

Liquid-Liquid Phase Separation Induced by Vapor Transfer in Evaporative Binary Sessile Droplets

Morphology Characteristics of the Liquid–Vapour Interface in Porous Media

Droplet Formation via Solvent Shifting in a Microfluidic Device

Evaporation-inducedself-assembly of Uniform Silica Microparticles with Mesoscopic Structures Via Spray Drying

Unveiling the Importance of Process Parameters on Droplet Shrinkage and Crystallization Behaviors of Easily Crystalline Material During Spray Drying

On evaporation dynamics of an acoustically levitated multicomponent droplet: evaporation-triggered phase transition and freezing

Evaporation Characteristics of a Single Desulfurization Wastewater Droplet in High-temperature Gas

Modeling Solution Drying by Moving a Liquid-Vapor Interface: Method and Applications

Anti-solvent Crystallization Behavior of Triphenylmethanol in a Droplet-Based Microfluidic Device

Characterization of Liquid‐Vapor Interfaces in Pores during Evaporation

Evaporation and Particle Deposition of Bi-Component Colloidal Droplets on a Superhydrophobic Surface

Structure Formation in Soft-Matter Solutions Induced by Solvent Evaporation.

Modulation of Evaporation-Affected Crystal Motion in a Drying Droplet by Saline and Surfactant Concentrations

Evaporation Induced Crystal Nucleation and Morphology of Dried Poly (Vinylidene Fluoride) Droplets

Modelling the primary drying stage of the spray freeze drying process based on the non-equilibrium formulation

Vapour-liquid rebalancing behaviour of free water evaporation kinetics: experimental investigation and modelling

Drying Pathways of an Evaporating Soft Matter Droplet

Modeling and Experimental Study of Vapor Phase-Diffusion Driven Sessile Drop Evaporation