Abstract:Molten salt electrolysis is one of the most important methods to produce rare earth metals and their alloys. In this method, mixtures consisting of rare earth chlorides and alkali chlorides are usually used as electrolytes. The knowledge of the thermodynamic properties of electrolytes is essential to design and improve the electrolytic process. The relationship between the composition and the primary crystal temperature can be obtained through the phase diagram of the molten salt. Then the electrolysis temperature and electrolyte composition can be initially determined, which lays a foundation for further study of other properties. Since the most commonly used alkali chlorides in industry are LiCl, NaCl and KCl, the phase equilibrium data of LiCl-NaCl-KCl are bases for constructing the thermodynamic database of multicomponent chloride melts containing rare earths. This paper mainly focuses on the thermodynamic properties of the binary system LiCl-NaCl and the ternary system LiCl-NaCl-KCl. With regard to the binary system LiCl-NaCl, numerous researchers have used the thermal analysis method to experimentally measure its phase diagram. However, the data obtained by different researchers are quite different. Whether there exist intermediate compounds and whether it is an isomorphous phase diagram is still not confirmed. Furthermore, the existing experimental data were mostly measured by the cooling curve method from 1910 to 1960 and they are generally not consistent with each other. Besides, the deviation between the recently calculated phase diagram and experimental data is somewhat large. For instance, the temperature deviation between the calculated and measured solidus can be up to 30 K. With respect to the ternary system LiCl-NaCl-KCl, the measurement of the phase diagram has been performed by many researchers and the thermodynamic optimization has also been carried out. However, there is significant difference among these experimental data. And the results of previous optimization are inconsistent with FTsalt database of FactSage software. For example, there is an eutectic point in the liquidus projection of the phase diagram of LiCl-NaCl-KCl at 619 K, while according to the Fact Sage software there is only a minimum instead of an eutectic point and the temperature is 621 K. Therefore, the phase diagrams of LiCl-NaCl and LiCl-NaCl-KCl systems were measured using differential thermal analysis in this work. Then these systems were thermodynamically optimized based on the measured data, including phase diagram, enthalpy of mixing, activity, etc, in previous and current work using CALPHAD method. During the optimization, the modified quasichemical model was used to describe the liquid solution while the Compound Energy Formulism was employed to model the solid solution. According to our calculation. LiCl-NaCl has an isomorphous phase diagram with a minimum at xNuct=0.262 and 7' =820 K. Compared with the previous optimization results, the solidus calculated in this paper is closer to the experimental value. The calculated temperature at which the solid solution undergoes phase separation is within the range of experimental data. Apart from that, there is a minimum in the liquidus projection of LiCl-NaCl-KCl system, rather than a four -phase eutectic point. The corresponding component is 55%LiCl-8%NaCl-37%KCl and the temperature is 620 K, which is in common with the literature. Therefore, the thermodynamic parameters obtained in this work are more reasonable.

Experimental Measurement and Thermodynamic Optimization of the Phase Diagram of LiCl-NaCl-KCl System

Thermodynamic Evaluation and Optimization of the (licl + NaCl + KCl + MgCl2 + CaCl2 + CeCl3) System

Experimental Measurements and Thermodynamic Optimization of the NaCl+RbCl Phase Diagram

Evaluation of Surface Tension of ACl-CeCl3 (A=Li, Na, K, Cs)

Thermodynamic Evaluation of LiCl-KCl-PuCl3 System

PHASE DIAGRAM OF SYSTEM NdCl_3-LiCl-KCl

Phase Equilibria for the Aqueous Quinary System Li + , Na + , K + , Mg 2+ //Cl – –H 2 O Saturated with NaCl·2H 2 O at 258.15 K

Phase Diagram of the Quaternary System LiCl+MgCl2+KCl+H2O at 323.15 K

Thermodynamic modeling of the LiCl-KCl-LaCl$_3$ system with Bayesian model selection and uncertainty quantification

Calculated Thermodynamic Properties of GdCl3 in LiCl-KCl Eutectic Molten Salt

Measurement and Model Prediction of Solid-Liquid Equilibrium in the Ternary System KCl-MgCl2-H2O at 293.15, 298.15, 303.15, and 308.15 K

A Density Model Based on the Modified Quasichemical Model and Applied to the (licl+kcl+cscl) Liquid

Molecular dynamics simulation of microstructure and thermophysical properties of LiCl–CaCl 2 eutectic molten salt

The Influence of NaCl Concentration on the (Licl-Kcl) (eutectic) System and Temperature Dependence of the Ternary System

Study on preparation and thermal properties of mixed chloride salts

Thermodynamic Assessment of Binary Chloride Salt Material for Heat Transfer and Storage Applications in CSP System

Thermodynamic Description of the K, Be//F, Cl Salt System with First-Principles Calculations

Coordination and Thermophysical Properties of Transition Metal Chlorocomplexes in LiCl-KCl Eutectic.

Liquidus Temperatures and Thermodynamic Properties of the Kcl-Kno2, Nacl-Nano2, and Kno2-Nano2 Systems

Phase Equilibrium and Evaporation Process Simulation for the Lithium Recovery from NaCl-LiCl-H2O System with High Presence of Organic NMP

Thermodynamic Evaluation and Optimization of (lif + ReF3) (re = La, Nd, Gd, Yb, Y, Lu) Binary Systems