Abstract:Reconfigurable intelligent surface (RIS)-aided terahertz (THz) communications have been regarded as a promising candidate for future 6G networks because of its ultra-wide bandwidth and ultra-low power consumption. However, there exists the beam split problem, especially when the base station (BS) or RIS owns the large-scale antennas, which may lead to serious array gain loss. Therefore, in this paper, we investigate the beam split and beamforming design problems in the THz RIS communications. Specifically, we first analyze the beam split effect caused by different RIS sizes, shapes and deployments. On this basis, we apply the fully connected time delayer phase shifter hybrid beamforming architecture at the BS and deploy distributed RISs to cooperatively mitigate the beam split effect. We aim to maximize the achievable sum rate by jointly optimizing the hybrid analog/digital beamforming, time delays at the BS and reflection coefficients at the RISs. To solve the formulated problem, we first design the analog beamforming and time delays based on different RISs physical directions, and then it is transformed into an optimization problem by jointly optimizing the digital beamforming and reflection coefficients. Next, we propose an alternatively iterative optimization algorithm to deal with it. Specifically, for given the reflection coefficients, we propose an iterative algorithm based on the minimum mean square error technique to obtain the digital beamforming. After, we apply LDR and MCQT methods to transform the original problem to a QCQP, which can be solved by ADMM technique to obtain the reflection coefficients. Finally, the digital beamforming and reflection coefficients are obtained via repeating the above processes until convergence. Simulation results verify that the proposed scheme can effectively alleviate the beam split effect and improve the system capacity.

Practical Hybrid Beamforming With Finite-Resolution Phase Shifters for Reconfigurable Intelligent Surface Based Multi-User Communications

Hybrid Beamforming for Reconfigurable Intelligent Surface based Multi-User Communications: Achievable Rates With Limited Discrete Phase Shifts

Beamforming Design for Multiuser Transmission Through Reconfigurable Intelligent Surface.

Secure Beamforming Design for Reconfigurable Intelligent Surface Assisted Downlink Transmission

A Robust Deep Learning-Based Beamforming Design for RIS-Assisted Multiuser MISO Communications with Practical Constraints

Joint Hybrid 3D Beamforming Relying on Sensor-Based Training for Reconfigurable Intelligent Surface Aided TeraHertz-Based Multiuser Massive MIMO Systems

Robust Beamforming for RIS-Assisted Wireless Communications with Discrete Phase Shifts.

Beamforming Design for Reconfigurable Intelligent Surface Enhanced Full-duplex Ambient Backscatter Communication Networks

Hybrid Beamforming with Discrete Phase Shifts for RIS-Assisted Multiuser SWIPT System.

Reconfigurable Intelligent Surface Aided Hybrid Beamforming: Optimal Placement and Beamforming Design

Beamforming Analysis and Design for Wideband THz Reconfigurable Intelligent Surface Communications

Efficient Design for Multi-user Downlink Beamforming with Reconfigurable Intelligent Surface

Sharing the Surface: RIS-aided Distributed Mechanism Design for Hybrid Beamforming in Multi-cell Multi-user Networks

Joint design of hybrid beamforming and reflection coefficients for reconfigurable intelligent surface aided mmWave communication systems

Beamforming Design for Double-Active-RIS-aided Communication Systems with Inter-Excitation

RIS Partitioning Based Scalable Beamforming Design for Large-Scale MIMO.

GMD-Based Hybrid Beamforming for Large Reconfigurable Intelligent Surface Assisted Millimeter-Wave Massive MIMO

A Practical Beamforming Design for Active RIS-assisted MU-MISO Systems

Joint Beamforming Design for Multiuser MISO Downlink Aided by a Reconfigurable Intelligent Surface and a Relay

Multi-user passive beamforming in RIS-aided communications and experimental validations

Joint Beamforming and Reflecting Design in Reconfigurable Intelligent Surface-Aided Multi-User Communication Systems