Sorption study of [Cu(Cl)(NH)] by Cu(II) in sponge Metalzorb for wastewater remediation

Rachel Lombana-Fraguela,Ana Rosa Lazo-Fraga,Alicia Díaz-García,Margarita Villanueva-Tagle,Montserrat Resina-Gallego,Xiang-Yang Lou,Manuel Valiente-Malmagro

DOI: https://doi.org/10.1016/j.matchemphys.2023.127921

IF: 4.778

2023-09-01

Materials Chemistry and Physics

Abstract:The increasing use of cytostatic in cancer therapy, with new antitumor agents, such as copper complexes, has become a serious environmental problem due to their high toxicity, even at low concentrations. Various sorbent materials have been used to remove these contaminants in wastewater. However, these sorbents present some difficulties related to waste management and have a high cost. One of the sorbents with satisfactory results for the retention of heavy metals is the Metalzorb™ sponge. This material is a high porous and economic ion exchange material with selective affinity to retain heavy metals in both cationic and anionic states. Such material is able to promote high rates of adsorption and flexibility, which enables their compressibility into an extremely small volume to facilitate its disposal once the capacity of the material has been exhausted. The objective of this work was the selection of the best conditions for the batch sorption process in Metalzorb™ sponge of trans-[Cu(Cl)2(NH3)2] in dissolution. For this, the synthesis process of the compound and its characterization by Infrared Spectroscopy and X-ray Diffraction were optimized. The best results were obtained for pH 8, in a solution volume of 15 mL, m/V = 1 g L−1 and a contact time of 60 min. The experimental data were adjusted to kinetic and equilibrium models for 25, 50 and 70 °C, obtaining a maximum capacity approximated to 49 mg g−1 meaning a 98% retention in all cases.

materials science, multidisciplinary