Abstract:Mode transition control is a critical issue of Turbine-Based-Combined Cycle (TBCC) engines when the primary thrust providers change from gas turbine engines to ramjets/scramjets. During mode transition, windmilling operation is inevitable when the fuel mass flow rate of the turbojet engine is decreasing to zero gradually. Existed research on mode transition control of TBCC engines usually neglect this process or simplify this process to a rapid thrust loss due to lacking a windmilling model. However, the absence of the windmilling model might cause critical problems unconsidered at the control system design stage and increase the risk of mission abortion. This paper provides a method of modeling the windmilling operation of a TBCC engine. Sub-idle compressor component maps are obtained by the interpolation method based on a zero-speed line to consider the characteristics that the total pressure ratio is below one. Friction torque is added in the torque balance relationship to achieve the free windmilling operation state when both the compressor and the turbine provide positive torques. The inlet start/unstart status coupled with the operating point of the turbojet engine is also considered. Results show that this model could reflect the characteristics that the total pressure ratio of the compressor is below one, and it provides a positive torque instead of a negative one when the turbojet engine operates at some sub-idle states. Moreover, inlet unstart would happen at some point when the turbojet engine is shutting down to the free windmilling state, under which the turbojet engine would bring in the flight drag instead of a positive thrust. In the descent mode transition when the turbojet engine is accelerating to be restarted, an inappropriate rotating speed of the inlet splitter could result in a fail inlet restart.

Analysis of Aerodynamic/propulsive Couplings During Mode Transition of Over-under Turbine-Based-combined-cycle Engines

Modeling and Analysis for Integrated Airframe/propulsion Control of Vehicles During Mode Transition of Over-under Turbine-Based-Combined-Cycle Engines

Modeling and Analysis of Windmilling Operation During Mode Transition of a Turbine-Based-combined Cycle Engine

Mode transition path optimization for turbine-based combined-cycle ramjet stage under uncertainty propagation of integrated airframe-propulsion system

Research on the design method of mode transition control law for Ma6 external parallel TBCC engine

Multi-fidelity simulation of inlet mode transition with smooth thrust of turbine based combined cycle

Modeling and mode transition simulation of over-under turbine based combined cycle (TBCC) propulsion system based on inlet/engine matching

Trajectory Optimization for a TBCC-powered Supersonic Vehicle with Transition Thrust Pinch

Research on Adaptive Cycle Engine Mode Transition Control Method

Design of Transition State Control Method for Civil Aviation Engine Facing NOx Emission Reduction Target

Mode Transition Analysis of a Turbine-Based Combined-Cycle Considering Ammonia Injection Pre-Compressor Cooling and Variable-Geometry Ram-Combustor

Distributed Parameter Control Arithmetic for an Axisymmetrical Dual-Mode Scramjet

Investigation of translation scheme turbine-based combined-cycle inlet mode transition

Modeling and Coupling Characteristics for an Airframe-Propulsion-integrated Hypersonic Vehicle

Mode Transition Control Law Analysis of Ammonia MIPCC Aeroengine Considering Inlet–compressor Safety Matching

Thermodynamic cycle analysis of the fuel precooled multi-mode turbine engine mode transition process: Why? When? How?

A Model of Mode Transition Logic in Dual-Mode Scramjet Engines

Analysis of the impact of key similarity criteria numbers of TBCC inlet during the mode transition

Predictive control method for mode transition process of multi-mode turbine engine based on onboard adaptive composite model

Performance Uncertainty Propagation Analysis for Control-Oriented Model of a Turbine-Based Combined Cycle Engine

An Integrated Controller Design for a Small Aero-Engine