Abstract:Reactor protection system (RPS) is one of the most important safety systems in nuclear power plant (NPP). A RPS usually consists of 4 redundant channels, in which a triggering signal is generated to safely shut down the reactor if necessary. The reliability analysis and assessment of RPS is a very important aspect which has been received widespread concern. Fault tree analysis (FTA) and Markov chain are two conventional reliability analysis methods for RPS. However, FTA is a static methodology which can not model the periodic surveillance test (PST) and maintenance. And Markov chain is only applicable for the exponential distribution process, whereas the failure and maintenance process for RPS do not always follow exponential distribution. Moreover, the RPS will degrade the voting logic from 2-outof-4 to 2-out-of-3 during the PST. In fact, there are few models consider this degradation process. In this paper, a dynamic reliability model for the RPS is proposed based on Petri nets. The dynamic transition processes of all states are described by Petri nets, in which the PST and maintenance are considered. Different from other models assuming the PST process following an exponential distribution, a deterministic time duration of the PST is adopted in this model. During the PST, the degradation process that voting logic transit from 2- out-of-4 to 2-out-of-3 is determined. The correctness and applicability of the model are analyzed by comparing the analytical solution and numerical solution. A comparison among the other two models and the proposed model is simulated. The result shows that degradation process voting logic from 2-out-of-4 to 2-out-of-3 will significantly increase the instantaneous unavailability during the PST. Therefore, it is indeed necessary to accurately model maintenance process and the degradation process result from that for RPS.

Simulation Study of Reactor Protection System Periodic Test Using Monte Carlo Method

Reliability Simulation of System with Periodic Test Based on Monte Carlo Method

Preliminary Research of Reactor Protection System Reliability Based on Monte Carlo Methods

Real-time simulations to enhance distributed on-line monitoring and fault detection in Pressurized Water Reactors

Research On Monte Carlo Perturbation Calculation Methods Applied In Reactor Physics

Research on perturbation based Monte Carlo reactor criticality search

Dynamic Reliability Assessment of Protection System Based on Dynamic Fault Tree and Monte Carlo Simulation

Application of MC Method to Simulate Initiating Event Frequency of Loss of Equipment Cooling Water System in Nuclear Power Plants

Research of Test Scenario of T2 Response Time of Reactor Protection System

Perturbation Based Monte Carlo Criticality Search in Density, Enrichment and Concentration

A method to estimate the initiating event frequency by Monte Carlo Simulation

Adaptive Sequential Importance Sampling Technique for Short-Term Composite Power System Adequacy Evaluation

Operation Assessment of Service Water Systems under Periodic Inspection and Maintenance

The development of Petri net-based continuous Markov chain Monte Carlo methodology applying to dynamic probability risk assessment for multi-state resilience systems with repairable multi-component interdependency under longtermly thereat

Reliability Analysis for Continuous Operation System in Nuclear Power Plant

Petri nets based reliability modeling of reactor protection system considering periodic surveillance test

System Safety Analysis Method Based on Real-Time Online Risk Monitoring Technology

Kinetic Methods in Monte Carlo Code RMC and Its Implementation to C5G7-TD Benchmark

Monte Carlo method for analyzing research reactor shielding

Reliability Modeling and Analysis of Reactor Protect System Based on Petri Net

Monte Carlo simulation of K12 factor of 16N monitor applied in pressurized water reactor