Effect of adiabatic ground on thermofluidic behavior and cooling time analysis from a hollow tube

Aayush Shah,Basanta Kumar Rana
DOI: https://doi.org/10.1080/10407790.2023.2299681
2024-01-05
Numerical Heat Transfer Part B Fundamentals
Abstract:Efforts are made to elucidate natural convection around a tube placed on/close to the adiabatic ground in a stagnant ambient air within laminar regime. Thermofluidic characterization is carried out by employing important governing input quantities, such as Rayleigh number (102≤Ra≤106), gap (0≤S/L≤1), and aspect ratio (0.1≤L/D≤20). The heat loss rate from the inner surface drops abruptly when the tube is placed on the ground. The growth rate of heat loss rate with S/L is relatively more abrupt at higher value of L/D for a constant Ra. Nusselt number on outer wall (Nuow) is found to increase monotonically as L/D grows continually for a constant S/L and Ra, whereas an opposite trend is anticipated for Nusselt number on inner wall (Nuiw). The reduction gradient of Nuiw with L/D is considerably lower at lower value of S/L in comparison to higher S/L. Again, two distinguished zones are identified (Zone A and B), namely, (i) zone A, where the effect of ground on the thermofluidic behvaiour around the tube is observed, and (ii) zone B suggests no effect of ground. Furthermore, cooling time estimation is performed by considering the initial temperature (Ti) of the cylinder as the wall temperature (Tw) at time t= 0 s. The required cooling time reduces considerably with the rise of S/L for a particular Ra and L/D. Lastly, a new correlation for Nusselt number has been anticipated. It shows quite satisfactory agreement within ±6% of the computational data.
thermodynamics,mechanics
What problem does this paper attempt to address?