Abstract:The treatment of nanoparticle (NP) polluted aqueous suspensions by flotation can be problematic due to the low probability of collision between particles and bubbles. To overcome this limitation, the present work focuses on developing an enhanced flotation technique using the surface-functionalized micro-bubbles - colloidal gas aphrons (CGAs). The CGA generator was adapted to be air flow rate controlled based on the classical Sebba system; thus it could be well adopted in a continuous flotation process. Cetyl trimethylammonium bromide (CTAB) and sodium dodecyl sulfate (SDS) were employed for CGA creation. Positively surface-charged CTAB-CGAs (similar to 44.1 mu m in size) and negatively surface-charged SDS-CGAs (similar to 42.1 mu m in size) were produced at the optimum stirring speed of 8000 rpm. The half-life of CGAs varied from 100 s to 340 s under the tested conditions, which was largely sufficient for transferring CGAs from bubble generator to flotation cell. The air flow led to less stable CTAB-CGAs but apparently enhanced the stability of SDS-CGAs at higher air flow rates. In the presence of air flow, the drainage behavior was not much related to the type of surfactants. The continuous CGA-flotation trials highlighted the effective separation of silica nanoparticles - the removal efficiencies of different types of SiO2 NPs could reach approximately 90%-99%; however, at equivalent surfactant concentrations, no greater than 58% of NPs were removed when surfactants and bubbles were separately added into the flotation cell. The SiO2 NPs with small size were removed more efficiently by the CGA-flotation process. For the flotation with CTAB-CGAs, the neutral and basic initial SNP suspension was recommended, whereas the SDS-CGAs remained high flotation efficiency over all investigated pH. The good performance of CGA-flotation might be interpreted: most of the surfactant molecules well covered/coated on the surfaces of stable CGAs and thus fully contacted with NPs, resulting in the efficient utilization of surfactants. (C) 2017 Elsevier Ltd. All rights reserved.

Lability-specific Enrichment of Typical Engineered Metal (oxide Nanoparticles by Surface-Functionalized Microbubbles from Waters

What Occurs in Colloidal Gas Aphron-Induced Separation of Titanium Dioxide Nanoparticles? Particle Fate Analysis by Tracking Technologies.

Surface-modified Microbubbles (colloidal Gas Aphrons) for Nanoparticle Removal in a Continuous Bubble Generation-Flotation Separation System.

Polyaluminum Chloride-Functionalized Colloidal Gas Aphrons for Flotation Separation of Nanoparticles from Water.

Coagulative Colloidal Gas Aphrons Generated from Polyaluminum Chloride (pacl)/dodecyl Dimethyl Betaine (BS-12) Solution: Interfacial Characteristics and Flotation Potential

Transformation of CuO Nanoparticles in the Aquatic Environment: Influence of Ph, Electrolytes and Natural Organic Matter

Optimization for Silver Remediation from Aqueous Solution by Novel Bacterial Isolates Using Response Surface Methodology: Recovery and Characterization of Biogenic AgNPs.

Effect of Size and Surface Chemistry of Gold Nanoparticles on Their Retention in a Sediment-Water System and Lumbriculus Variegatus.

Interactions of Metal Oxide Nanoparticles with Extracellular Polymeric Substances (EPS) of Algal Aggregates in an Eutrophic Ecosystem

Enrichment of Pb, Cu and Zn on Ferromanganese Oxides from Surface Coatings Collected in Natural Water

Aggregation Behaviour of Engineered Nanoparticles in Natural Waters: Characterising Aggregate Structure Using On-Line Laser Light Scattering.

New Insights into the Facilitated Dissolution and Sulfidation of Silver Nanoparticles under Simulated Sunlight Irradiation in Aquatic Environments by Extracellular Polymeric Substances

Aggregation Behavior of Engineered Nanoparticles and Their Impact on Activated Sludge in Wastewater Treatment.

Stability and Mobility of Zinc Oxide Nanoparticles in Aquatic Environment: Influence of Extracellular Polymeric Substances from Cyanobacteria and Microalgae

Speciation Analysis of Ag2S and ZnS Nanoparticles at the Ng/l Level in Environmental Waters by Cloud Point Extraction Coupled with LC-ICPMS

Depth-dependent Transformation of ZnO and Ag Nanoparticles in Sulfate-reducing Sediments Tracked using Scanning Transmission Electron Microscopy

Physicochemical Transformation and Algal Toxicity of Engineered Nanoparticles in Surface Water Samples.

Application of Nanoparticle Tracking Analysis for Characterising the Fate of Engineered Nanoparticles in Sediment-Water Systems

Effects of natural organic matter and sulfidation on the flocculation and filtration of silver nanoparticles

Dispersive Liquid–liquid Microextraction of Silver Nanoparticles in Water Using Ionic Liquid 1-Octyl-3-methylimidazolium Hexafluorophosphate

Enrichment of Nanoplastics in Waters Using Magnetic Solid Phase Extraction With Magnetic Biochar Adsorbents and Their Determination by Pyrolysis Gas Chromatography‐Mass Spectrometry