Nano-spherical Fe3O4 modified NixSy@SiMPs composite materials improve photoelectrochemical performance
Zhuo Zhong,Wanjun Chen,Xiaojia Chen,Jie Li,Haihua Yang,Li Zhang,Peng Yang
DOI: https://doi.org/10.1007/s10854-024-12020-w
2024-01-28
Journal of Materials Science Materials in Electronics
Abstract:More catalytic active sites and fast interfacial charge transfer rates have been shown to be effective strategies to enhance photocatalytic water decomposition. In this work, a microconical textured silicon wafer was constructed by wet chemical etching. Fe 3 O 4 nanospheres and Ni x S y (NiS and Ni 3 S 4 complexes) nanoclusters were prepared by solvothermal method, and Fe 3 O 4 and Ni x S y were deposited on Si micropyramids (denoted as Fe 3 O 4 /NiS/Ni 3 S 4 @SiMPs) by drop-coating methods. Fe 3 O 4 /NiS/Ni 3 S 4 @SiMPs exhibited excellent photoelectrochemical properties and good stability at the composite ratio of Fe 3 O 4 to Ni x S y was 1:5, and the starting potential of the composite was 0.29 V vs.RHE, maximum photohydrogen conversion efficiency was 0.32% (+ 1.21 V vs. RHE), photocurrent density was 0.82 mA cm −2 . Fe 3 O 4 /NiS/Ni 3 S 4 @SiMPs exhibited 42 times higher photocurrent density than NixSy@SiMPs with long-term stability was up to 4 h. The results show that Fe 3 O 4 significantly improved the photoelectrochemical performance of Ni x S y @SiMPs composites, mainly because that Fe 3 O 4 nanospheres have high conductivity contributing to photogenerated carrier migration, and the heterojunction between semiconductors with different energy levels (Fe 3 O 4 , Ni x S y , Si) effectively inhibited the recombination of electrons and holes. This work provides directions for the preparation and photoelectrochemical properties of monocrystalline silicon-based supported Ni x S y and Fe 3 O 4 composites.
engineering, electrical & electronic,materials science, multidisciplinary,physics, condensed matter, applied