Mixing Characteristics of a Film-Exciting Flapping Jet

M. Wu,M. Xu,J. Mi,R. C. Deo

DOI: https://doi.org/10.1016/j.ijheatfluidflow.2019.108532

IF: 2.643

2020-01-01

International Journal of Heat and Fluid Flow

Abstract:We have recently discovered a new type of self-excited flapping jets due to a flexible film whose leading edge is fixed at the nozzle exit [Exp Ther Fluid Sci, 106, 226-233]. This paper is to report the experimental investigation on mixing characteristics of the jet induced by a rectangular FEP film. Hot wire anemometry and flow visualization are used to examine the flapping jet flow versus the non-flapping counterpart. Experiments are conducted under the following conditions: i.e., L/D = 1.0 (fixed), W/D = 0.03 similar to 1.0 (varying) and Re = 10000 similar to 45000 (varying); where W and L are the film's width and length, D is the nozzle-exit diameter, and Re is the Reynolds number defined by R-e equivalent to U0D/v with U-o and v being the jet-exit velocity and fluid viscosity. It is found that the jet-flapping frequency fp varies with W in a complex fashion while it grows roughly linearly with increasing U. for W/D 0.5. The flapping Strouhal number St(F) equivalent to f(F)D/U-0 ranges in 0.13 <= St(F) <= 0.23 for Re = 15,000 similar to 45,000. These Strouhal numbers are substantially lower than that (approximate to 0.45 - 0.7) for the primary vortex generation in the free jet, but one to two orders of magnitude higher than those from the conventional self-exciting fluidic devices. In general, the flapping jet decays and spreads more rapidly than does the free jet. As W increases, the decaying and spreading rates both grow. Of significance, the centerline evolutions of Taylor and Kolmogorov scales versus the integral scale are examined to characterize the small scales of turbulence against the large-scale motion.