Abstract:Wireless networks are built upon a shared medium that makes it easy for adversaries to launch jamming-style attacks. These attacks can be easily accomplished by an adversary emitting radio frequency signals that do not follow an underlying MAC protocol. Jamming attacks can severely interfere with the normal operation of wireless networks and, consequently, mechanisms are needed that can cope with jamming attacks. In this paper, we examine radio interference attacks from both sides of the issue: first, we study the problem of conducting radio interference attacks on wireless networks, and second we examine the critical issue of diagnosing the presence of jamming attacks. Specifically, we propose four different jamming attack models that can be used by an adversary to disable the operation of a wireless network, and evaluate their effectiveness in terms of how each method affects the ability of a wireless node to send and receive packets. We then discuss different measurements that serve as the basis for detecting a jamming attack, and explore scenarios where each measurement by itself is not enough to reliably classify the presence of a jamming attack. In particular, we observe that signal strength and carrier sensing time are unable to conclusively detect the presence of a jammer. Further, we observe that although by using packet delivery ratio we may differentiate between congested and jammed scenarios, we are nonetheless unable to conclude whether poor link utility is due to jamming or the mobility of nodes. The fact that no single measurement is sufficient for reliably classifying the presence of a jammer is an important observation, and necessitates the development of enhanced detection schemes that can remove ambiguity when detecting a jammer. To address this need, we propose two enhanced detection protocols that employ consistency checking. The first scheme employs signal strength measurements as a reactive consistency check for poor packet delivery ratios, while the second scheme employs location information to serve as the consistency check. Throughout our discussions, we examine the feasibility and effectiveness of jamming attacks and detection schemes using the MICA2 Mote platform.

Analysis of the Effect Jammer Types on GNSS Receiver Measurements

The Interference Effect Evaluation Indicators of Radar Based on Penetration Path

Experimental Evaluation of the Impact of Different Types of Jamming Signals on Commercial GNSS Receivers

The Feasibility of Launching and Detecting Jamming Attacks in Wireless Networks.

Protecting GNSS Receivers from Jamming and Interference

Novel Anti-Jamming Algorithm for GNSS Receivers Using Wavelet-Packet-Transform-Based Adaptive Predictors

Exploiting Jamming-Caused Neighbor Changes for Jammer Localization

A Comparative Analysis of the Response of GNSS Receivers under Vertical and Horizontal L1/E1 Chirp Jamming

Analysis of Multi-Antenna GNSS Receiver Performance under Jamming Attacks

Analysison Anti-jamming Technology for Satellite Navigation Receiver

Impact Analysis of Orthogonal Circular-Polarized Interference on GNSS Spatial Anti-Jamming Array

Analysis of Jamming on TT & C Monopulse Tracking System

Enhanced GNSS Reliability on High-Dynamic Platforms: A Comparative Study of Multi-Frequency, Multi-Constellation Signals in Jamming Environments

A Two-Stage Interference Suppression Scheme Based on Antenna Array for GNSS Jamming and Spoofing

Research on GNSS generating spoofing jamming technology

A Real Data Based Carrier-to-Noise Density Ratio Evaluation of GNSS Signal in Interference Environment

GPS Receiver Performance Simulation and Analysis under Strong Interference

First results from three years of GNSS Interference Monitoring from Low Earth Orbit

Anti-jamming Design of FPGA-based GNSS Receiver

Anti-Jamming Method and Implementation for GNSS Receiver Based on Array Antenna Rotation

An Anti-Jamming GPS Receiver Based on Subspace Decomposition Method