Abstract:The reliable measurement of pressures on low-rise buildings in the atmospheric boundary layer (ABL) flow remains a challenge, as has been shown by the large discrepancies among results obtained in different wind tunnel facilities or even in the same wind tunnel. Two major causes of the discrepancies are the difficulty of simulating large-scale, low-frequency turbulent fluctuations uniformly across laboratories and the small scale of models in typical civil engineering wind tunnels. To address these issues, it was proposed that a simplified flow be used in laboratory simulations, rather than a conventional ABL flow. In the simplified flow the reference mean wind speed is larger than the mean wind speed of the ABL flow, and the low-frequency fluctuations present in the ABL flow are suppressed; that is, the peak energy of the missing low-frequency fluctuations is supplied in the simplified flow by the increment in the mean wind speed, which may be regarded as a flow fluctuation with zero frequency. High-frequency turbulent fluctuations, which typically affect flow reattachment, are approximately the same in the ABL and the simplified flow. Because, over small distances, low-frequency fluctuations are highly coherent spatially for small low-rise buildings with dimensions of up to approximately 20 m (e.g., single-family residential homes), the peak aerodynamic effects of the two flows may be hypothesized to be approximately the same. Preliminary experimental results obtained in University of Western Ontario’s ABL wind tunnel facility and Florida International University’s small-scale Wall of Wind facility are shown to support this hypothesis. The use of the proposed simplified flow is currently being tested by the authors for application to computational wind engineering (CWE) applications. Such use eliminates the need to simulate the lower frequency fluctuations of the boundary layer flow and thus makes it possible to achieve practical CWE calculations, and it is advantageous in experiments from the points of view of measurement accuracy, model scaling, repeatability of the simulations, and computational efficiency.

Artificial Simulation of Complex Unsteady Wind in an ABL Wind Tunnel with Dual Axial Fans

Optimal design of sand blown wind tunnel

Development of a large recirculating boundary-layer wind tunnel

A Wind Energy Generation Replication Method with Wind Shear and Tower Shadow Effects

The reproduction of 2-D non-synoptic wind field in an actively controlled wind tunnel

Combining Application of Wavelet Analysis and Genetic Algorithm in Wind Tunnel Simulation of Unidirectional Natural Wind Field Near a Sand Ground Surface.

Numerical Simulation of Atmospheric Boundary Layer Turbulence in a Wind Tunnel Based on a Hybrid Method

Modeling the Evolution of Aeolian Sand Transport in a Wind Tunnel

A New Controllable Weak Recycling Inflow Turbulence Generator for Evaluating Wind Effects on Building in LES

On the Mechanism and Influence of the Delayed Effect of Longitudinal Ventilation in Urban Tunnels

A new atmospheric boundary layer wind tunnel simulation methodology for wind effects on large cooling towers considering wind environment variations

An Equivalent Analysis of Unsteady Sand Transport in a Wind Tunnel

How to Design a 2D Active Grid for Dynamic Inflow Modulation

Active Simulation of Transient Wind Field in a Multiple-Fan Wind Tunnel via Deep Reinforcement Learning

A Wind Tunnel Experimental Study on the Wake Characteristics of a Horizontal Axis Wind Turbine

Versatile wind tunnel and CFD-based optimal design

An Experimental Investigation on Dynamic Wind Loads Acting on a Wind Turbine Model in Atomspheric Boundary Layer Winds

Simplified Wind Flow Model for the Estimation of Aerodynamic Effects on Small Structures

Wind Tunnel Simulation of Atmospheric Boundary Layer of Tropical Cyclone

LES Study of Wind Turbine Wake Meandering in the Atmospheric Boundary Layer

Numerical Simulation of Wind-Sand Current and Boundary Conditions in a Limited Space