Abstract:Abstract Additive Manufacturing (AM) of ceramics is a constantly emerging field of interest both in research and in industry. Binder jetting-based AM of ceramics in particular offers the opportunity to produce large ceramic parts with a high wall thickness at a high throughput. One limitation is that it requires flowable powders, which are generally coarse and thus exhibit only limited sintering activity. The resulting low sintered densities impede the commercial binder jetting-based production of dense oxide ceramics. We present an approach to efficiently increase the green density of binder jetted alumina parts by optimized slurry infiltration, which also leads to a significant increase in the sintered density. In a first step, alumina parts were fabricated via binder jetting, using a 20-μm-sized alumina powder, yielding relative green densities of about 47–49%. Initial sintering studies with powder compacts showed that sintering even above 1900 °C is not sufficient to achieve acceptable densification. Therefore, green samples were infiltrated with a highly filled ceramic slurry to fill the remaining pores (about 2–5 μm in size) with smaller particles and thus increase the packing density. Particle volume content (40–50 vol%), particle size (100–180 nm) and the infiltration procedure were adapted for tests on cuboid samples to achieve a high penetration of the green bodies and a high degree of pore filling. In this way, the relative green density could be increased starting from about 47% after binder jetting, to 73.4% after infiltration and drying. After sintering at 1675 °C densities above 90% could be achieved, yielding three-point bending strengths up to 145 MPa. As a conclusion, this approach can be regarded as a promising route for overcoming the drawbacks of the binder jetting process on the way to denser, mechanically more stable sintered alumina parts.

Hydrothermal-Assisted Transient Binder Jetting of Ceramics for Achieving High Green Density

Binder-free Additive Manufacturing of Ceramics Using Hydrothermal-Assisted Jet Fusion

Fabrication of Three-Dimensional Inter-Connective Porous Ceramics Via Ceramic Green Machining and Bonding

Process Optimization for Hydrothermal-Assisted Jet Fusion Additive Manufacturing of Ceramics

Hydrothermal Assisted Transient Jet Fusion of Ceramics: A Test Case Using Bentonite Clay

Postprocessing Study for the Controllable Structures of Ceramic Green Parts Realized by a Flexible Binder Jetting Printing (BJP) Solution

A thermal-initiated monomer binder enhancing green strength with low binder saturation for binder jetting additive manufacturing of cemented carbide

STUDY OF DROPLET DIFFUSION IN HYDROTHERMAL-ASSISTED TRANSIENT JET FUSION OF CERAMICS

Binder Jetting Additive Manufacturing of Ceramics: A Literature Review

Process Development of Porcelain Ceramic Material with Binder Jetting Process for Dental Applications

Improved green and sintered density of alumina parts fabricated by binder jetting and subsequent slurry infiltration

Enhancing the Capillary Force of Binder-Jetting Printing Ti6Al4V and Mechanical Properties under High Temperature Sintering by Mixing Fine Powder

Additive Manufacturing of Thin Alumina Ceramic Cores Using Binder-Jetting

Tailoring green and sintered density of pure iron parts using binder jetting additive manufacturing

Ceramic Binder Jetting Additive Manufacturing: A Literature Review on Density

Parameters Optimization of Binder Jetting Process Using Modified Silicate As a Binder

Slurry-based photoinitiator jetting process for ceramic additive manufacturing

A Versatile Thermally Initiated Crosslinking Binder for Additive Manufacturing of Strong Structures

Effect of Sintering Aid Combined Vacuum Infiltration on the Properties of Al2O3-based Ceramics Via Binder Jetting

Binder jetting of ceramics: Powders, binders, printing parameters, equipment, and post-treatment

Process development for green part printing using binder jetting additive manufacturing