Abstract:Due to the rapid adoption of Electric Vehicles (EVs) worldwide, On-Board/Off-Board Battery Chargers are facing numerous. One challenge is charging time since petrol and diesel vehicles are charged 10 times faster than electric vehicles. A second challenge is power density especially for the on-board chargers where minimal space for installation is allocated inside the vehicles. Another challenge is the wide battery voltage range which makes it difficult to optimize the converter over the entire battery voltage range and efficiency drops when either the battery voltage is too high or too lo.. Finally, the bi-directional operation is a challenge to allow the EV to support the grid in peak periods or even standalone loads. In this paper, a 6.6 kW two-stage structure is proposed utilizing a variable dc-link voltage operation. One of the most promising challenges in high-power applications is implementing the magnetics component into Printed Circuit Boards (PCBs). PCB winding transformers are widely in use in low power applications. Compared with conventional Iitz-wire transformers, the manufacturing process is greatly simplified and the parasitic is easier to control. However, due to the limitation of high winding loss and high multi-layer PCB cost in high power applications, the transformer design with PCB winding becomes a challenge. Emerging wide-bandgap devices provide the opportunity to adopt PCB transformers into high power applications. In addition, the low inductance requirement brought by high frequency also makes possible the realization of magnetic integration in PCB transformers.

High Power Integrated Charging System For Electrical Vehicles Based On Winding Multiplexing Of Pmsm

An Integrated BLIL Boost Converter-based Switched Reluctance Motor Drive for PEV Applications with PFC Charging Function

Efficiency Optimization of PMSM Drives Using Field-Circuit Coupled FEM for EV/HEV Applications

An Integrated Design of Power Converters for Electric Vehicles.

High-Frequency High-Density Bidirectional EV Charger

Split Converter-Fed SRM Drive for Flexible Charging in EV/HEV Applications

A Winding Multiplexing Method for Single-Phase and Three-Phase On-Board Integrated Battery Chargers Based on Multiphase Motor

Design and Implementation of a High-Power Modular WPT System

Winding Structure and Circuit Design of Contactless Power Transfer Platform

Design and Optimization of a Modular Wireless Power System Based on Multiple Transmitters and Multiple Receivers Architecture

Robust Control of Winding-Based DC-Bus Capacitor Discharge for PMSM Drives in Electric Vehicles

An Asymmetrical Loosely Coupled Transformer and Constant Current Wireless Charging Scheme for Warehouse Vehicles

Open Winding PMSM System for Electric Vehicles Collaboratively Supplied by the Z-Source and Voltage Source Converters

Design of a 300 Kw Partial Power Processing Based DC-DC Converter for Electric Vehicles Extreme Fast Charging Stations

Design and Implementation of a Motor Phase-access Integrated Boost Charging Scheme for Electric Vehicle

Research on the Integration of Hybrid Energy Storage System and Dual Three-Phase PMSM Drive in EV

A Multi-Inverter Multi-Rectifier Wireless Power Transfer System for Charging Stations With Power Loss Optimized Control

Electric vehicle integrated charging system for reconstructing open-winding permanent magnet motor by mode switch

A Multi-Functional Integrated Onboard Charger for Dual-Motor Driving EVs

Dual Stator Windings PMSG Fed by Half-Controlled Converters for Wind Power Application

Application of Modular Multilevel Converter in Medium Voltage High Power Permanent Magnet Synchronous Generator Wind Energy Conversion Systems