Abstract:The CFRP/metal co-cured material which possesses the outstanding properties of both lightweight and high strength has become one of the commonly used materials in the design and manufacture of attitude control flywheel. However, few studies are reported concerning the mechanical drilling operation of this newly developed structural material. To cover the gap and enrich the scientific field of this topic, the present work was performed to specially evaluate the drilling performances of a co-cured material composed of carbon fiber reinforced plastic (CFRP) and invar alloy. The significance of the present work aims to on the one hand, reveal the evolution of vital cutting phenomena including thrust forces, cutting temperatures and surface quality of drilling holes as function of cutting parameters, and on the other hand address the mechanism of controlling the interfacial drilling response. The results indicate that both the thrust forces and cutting temperatures during drilling of the invar phase are relatively higher compared to that of the CFRP phases while it presents elevation for the lower CFRP phase than the upper one due to the effect of chip ejection. The evolution of thrust forces and drilling temperatures present common regularity, in which the feed rate and cutting speed play an essential role, respectively. It is worth noting that the hole size indicates disparities for all the involved layers regardless of the machining parameters, of which the hole size exceeds the nominal diameter for the upper CFRP phase while it presents lower magnitudes for the lower CFRP phase and close gap between the invar phase and expected value. Surface cavity and fiber pullout dominate the hole surface morphology for the upper CFRP phase, matrix degradation and micro-cracks appear on the hole wall of the lower CFRP phase, and chip adhesion and oxidation are the cases for the invar layer. The mechanical effect induces the notch and the thermal effect causes the matrix degradation, which controls the cutting response for the upper and lower interface, respectively.

Experimental investigation on mechanical drilling of a newly developed CFRP/Al co-cured material

Experimental Study on Drilling Process of a Newly Developed CFRP/Al/CFRP Co-Cured Material

Study on the drilling performances of a newly developed CFRP/invar co-cured material

Study on Robot Automatic Drilling of Carbon Fiber Reinforced Plastics (CFRP)

Mechanism and feasibility study of low frequency vibration assisted drilling of a newly developed CFRP/Al co-cured material

Hole quality and tool wear when dry drilling of a new developed metal/composite co-cured material

An Investigation of Drilling High-Strength CFRP Composites Using Specialized Drills

Drilling Machinability Evaluation on New Developed High-Strength T800s/250f Cfrp Laminates

Experimental study on the hole machining process of a newly developed AFRP/Al/AFRP co-cured material: A comparative analysis of milling and drilling

Experimental investigation on drilling force and hole quality when drilling of T800s/250F CFRP laminate

Experimental Study on Mechanical Drilling of Carbon/epoxy Composite-Ti6al4v Stacks

Effects of Specialized Drill Bits on Hoe Defects of CFRP Laminates

A Study on Drilling High-Strength CFRP Laminates: Frictional Heat and Cutting Temperature

Experimental investigation on drilling of high strength T800S/250F CFRP with twist and dagger drill bits

Study of drilling-induced defects for CFRP composites using new criteria

Experimental investigation on drilling machinability and hole quality of CFRP/Ti6Al4V stacks under different cooling conditions

Machinability Of Drilling T700/Lt-03a Carbon Fiber Reinforced Plastic (Cfrp) Composite Laminates Using Candle Stick Drill And Multi-Facet Drill

Study on dedicated drill bit design for carbon fiber reinforced polymer drilling with improved cutting mechanism

Investigation on the cutting responses of CFRP/Ti stacks: With special emphasis on the effects of drilling sequences

Study on Burr Formation and Tool Wear in Drilling CFRP and Its Hybrid Composites

Study on Hole Wall Quality of Carbon Fiber Reinforced Composites Drilling Under Different Cutting Angles