Abstract:Reducing wall temperatures is a promising method to suppress knocking behavior in spark-ignited engine. However, this may increase undesirable heat loss which acts as countereffect, so a strategic cooling approach is required. In this study, a multidisciplinary investigation of the wall temperature effect was demonstrated using experiments and simulations. By experiments under full load and part load conditions, improvements in the indicated thermal efficiency achieved by knock-limited spark advancement were obtained, and detailed analyses were incorporated. Under cooled conditions, it was found that an improved thermal efficiency was achieved by not only the advanced combustion phasing but also the reduced compression work obtained from increased gas density, particularly under part load conditions. By categorizing and evaluating the heat transfer phases using simulations, it was found that the cooled wall temperature did not provide a significant gas temperature drop via compression and combustion processes. Unexpectedly, a notable contribution to gas heat transfer reduction arose during the early gas induction stage because of not only the extended period of heat transfer but also the large surface area and initial low temperature before compression. An enhanced cooling on cylinder head resulted in a larger effect on knock mitigation than enhanced liner cooling under normal conditions, attributed to the large heat transfer at the intake port wall. From the assessment, as the liner coolant dominated the piston surface, it was found that the contribution of the liner wall temperature to the gas temperature reduction was significantly influential, even showing a higher knock mitigation effect after intake port insulation was applied. Intensified tumble flow showed a high potential of gas temperature decrease by increasing the heat transfer from gas to wall during the compression stroke, and the effect of the enhanced cooling on the liner was more significant than that of the normal intake port due to the high velocity and turbulence of the air. The simulation results revealed that enhanced liner cooling could decrease the in-cylinder temperature by more than 18 K when insulation and intensification were both applied to the intake port design.

Analysis of Thermomechanical Stress of High-Temperature Ignition Surface Caused by Drop-Wall Interaction at Engine Conditions

Wall-impinging laminar premixed n-dodecane flames under autoignitive conditions

Characterizing Drop-Wall Interactions of Engine Fuels at Engine-Relevant Conditions Using Smoothed Particle Hydrodynamics

Thermal Load Analysis of Piston Damaged by Wall-Wetting Combustion in a Heavy-Duty Diesel Engine

A Phenomenological Thermal Spray Wall Interaction Modeling Framework Applied to A High Temperature Ignition Assistant Device

Numerical study of wall cooling effects on diesel spray combustion characteristics under different ambient conditions

Influence of the Wall Temperatures of the Combustion Chamber and Intake Ports on the Charge Temperature and Knock Characteristics in a Spark-Ignited Engine

New Insights into Abnormal Combustion Phenomena Induced by Diesel Spray-Wall Impingement under Engine-Relevant Conditions

Wall Temperature Effects on Ignition Characteristics of Liquid-phase Spray Impingement for Heavy-duty Diesel Engine at Low Temperatures

Experimental and numerical studies on fuel-film combustion and wall thermal effect of diesel spray

Thermal Stress Analysis of Ceramic-Coated Diesel Engine Pistons Based on the Wavelet Finite-Element Method

Thermo-mechanical analysis of a glass-ceramic piston for potential use in combustion engines

THERMAL STRESS ANALYSIS OF INTEGRATED COMBUSTION ENGINE PISTON USING CAE TOOLS (ALUMINUM SILICON ALLOY, ALUMINUM SILICON ALLOY STEEL)

Experimental study on the collision behaviors of micron-sized aluminum droplets with solid wall in high temperature burned gas

Investigation of Fuel Volatility on the Heat Transfer Dynamics on Piston Surface Due to the Pulsed Spray Impingement

The Impinging Wall Effect on Flame Dynamics and Heat Transfer in Non-Premixed Jet Flames

Research on Destructive Knock Combustion Mechanism of Heavy-Duty Diesel Engine at Low Temperatures

Dynamics of spray impingement wall film under cold start conditions

Droplet Wall/Film Impact in IC Engine Applications

Experimental and Numerical Analysis for the Dry Patch and Thermal Stress of One Heating Surface

Thermal and Conjugate Heat Transfer Analysis of Exhaust Manifold of Multi-cylinder IC Engine