Abstract:With the goal of fostering the circular economy, the present work was devised to minimize and manage agricultural waste by transforming it into biochar; a versatile dye removal adsorbent. Waterways across the globe are frequently fouled and contaminated with organic materials, especially via unregulated industrial effluents, producing toxic water supplies. Rhodamine B (RhB) and Methylene blue (MB) dyes were used as model organic pollutants in water. The contaminants were then readily extracted from environmental samples using sustainable wheat straw derived biochars. These materials were utilized in an effort to link the circular economy directly to environmental protection, reducing organic contamination by using a low carbon solution. Herein, two methods were adopted to refine a low temperature carbonized material, dependent on initial pre-treatment; leaching followed by milling (method-I) and milling followed by leaching (method-II). Scanning Electron Microscopy (SEM), nitrogen physisorption, proximate and ultimate analysis and Attenuated Total Reflectance-Fourier Transform Infrared Spectroscopy (ATR-FTIR) were used to examine the properties of the synthesized materials. It was found that by altering the process of initial waste pre-treatment, an increase in available surface area (6.284 m 2 g −1 –20.754 m 2 g −1 ) and pore structure can be found post feedstock pyrolysis. Additionally, FTIR of the biochar post extraction supported the adsorption process of both dyes, demonstrating a change in dye-adsorbent bonding, depending on the initial waste pre-treatment for the biochar. In batch mode, several operating parameters including pH, concentration, duration, and dose were optimized. Kinetics and adsorption isotherm studies for biochar synthesized by method-II pre-treatment (BC-II) revealed that the system follows Pseudo-first-order kinetics and Freundlich adsorption isotherm model with the relative R 2 of 0.9989 and 0.9880 for RhB, comparing with 0.9933 and 0.9932 for MB. The optimal produced biochar, BC-II effectively removed 91.06% of RhB from solution at pH 4 and 92.43% for MB at pH 8. This study brings forth a solution to enhance waste management by creating a circular scenario and alleviate environmental contamination by utilizing wheat straw as a biochar adsorbent, produced under controlled and low temperature conditions.

Preparation of activated carbon from sewage sludge using green activator and its performance on dye wastewater treatment

Dye adsorption properties of carbonized sludge and its application for treating dyeing wastewater

Activated Carbon Preparation from Pyrolysis Char of Sewage Sludge and Its Adsorption Performance for Organic Compounds in Sewage

Rapid Removal of Dyes by Carbonized Sludge: Process, Effects of Environmental Factors, and Mechanism

Activation of persulfate by iron‐loaded soybean straw biochar for efficient degradation of dye contaminants: Synthesis, performance, and mechanism

Application of Activated Carbons Obtained from Polymer Waste for the Adsorption of Dyes from Aqueous Solutions

Development of activated carbon from Eichhornia Crassipes via chemical activation and its application to remove a synthetic dye

Preparation of KOH and H3PO4 Modified Biochar and Its Application in Methylene Blue Removal from Aqueous Solution

Activated carbon prepared by co-pyrolysis of waste tobacco straw and waste LDPE mulch film: characterization and application for methylene blue removal

A Novel Low-Cost Bio-Sorbent Prepared from Crisp Persimmon Peel by Low-Temperature Pyrolysis for Adsorption of Organic Dyes

Microstructural tuning and high-efficiency adsorption performance of carbonaceous porous adsorbents from coal gasification fine slag for methylene blue removal

Preparation of activated carbon from waste cation exchange resin and its application in wastewater treatment

Adsorption performance and mechanism of cationic and anionic dyes by KOH activated biochar derived from medical waste pyrolysis

In-situ synthesis of efficient ZnCl2 doped pyrolyzed biochar for adsorptive remediation of organic dyes: Performance evaluation, mass transfer and mechanism

Preparation of porous biochar by urine assisted pyrolysis of sewage sludge and their application for Eriochrome Black T adsorption

Biochar from co-pyrolysis of biological sludge and woody waste followed by chemical and thermal activation: end-of-waste procedure for sludge management and biochar sorption efficiency for anionic and cationic dyes

Evaluating the pre-treatment protocol required to produce an effective carbonized waste adsorbent for organic pollution control

Enhanced adsorption of dye wastewater by low-temperature combined NaOH/urea pretreated hydrochar: Fabrication, performance, and mechanism

Adsorption experiments and mechanisms of methylene blue on activated carbon from garden waste via deep eutectic solvents coupling KOH activation

Sludge‐based Mesoporous Activated Carbon: the Effect of Hydrothermal Pretreatment on Material Preparation and Adsorption of Bisphenol A

Graded synthesis of high performance adsorbent from coal gasification fine slag and its application in the removal of methyl blue