Constructing Nanopores in Poly(oxymethylene)/multi-Wall Carbon Nanotube Nanocomposites Via Poly(l-Lactide) Assisting for Improving Electromagnetic Interference Shielding

Jie Li,Jia-Li Chen,Xiao-Hong Tang,Jie-Hua Cai,Ji-Hong Liu,Ming Wang
DOI: https://doi.org/10.1016/j.jcis.2020.01.057
IF: 9.9
2020-01-01
Journal of Colloid and Interface Science
Abstract:Lightweight and high-performance conductive polymer composites (CPCs) have attracted much attention for electromagnetic interference (EMI) shielding. Herein, the porous structure was constructed in poly (oxymethylene)/multi-wall carbon nanotube (POM/MWCNT) nanocomposites via assisting by poly(t, lactide) (PLLA). First, the POM/PLLA/MWCNT (S-PMLNT) nanocomposites were obtained by melt mixing and compression molding. Second, the nanoporous POM/MWCNT (P-PMNT) nanocomposites were fabricated by selectively dissolving PLLA, solvent exchanging and freeze-drying. Because of well miscible between PLLA and POM, the homogeneous nanopores could be successfully fabricated in the P-PMNT composites by removing the PLLA phase. The multiple reflections and scattering of microwaves happened on the walls of these nanopores, which endowed the P-PMNT nanocomposites having higher EMI shielding effectiveness (SE) in comparison of the S-PMLNT nanocomposites, although the P-PMNT nanocomposites exhibited the lower electrical conductivity. For example, the S-PMLNT samples with 10 wt% MWCNTs showed an EMI SE of 48.1 dB and an electrical conductivity of 333 S/m, which changed to 58.6 dB in EMI SE and 125 Sim in electrical conductivity after removing PLLA phase. Furthermore, the P-PMNT10 nanocomposites had outstanding the EMI normal SE (SE/d) of 29.3 dB mm(-1) and the EMI specific shielding effectiveness (SSE/d) of 344.4 dB cm(2) g(-1) because of their low density. In addition, the PPMNT nanocomposites maintained high compression and tensile strength simultaneously. (C) 2020 Elsevier Inc. All rights reserved.
What problem does this paper attempt to address?