Abstract:Stator-permanent-magnet (stator-PM) motor has garnered significant attention due to its high robustness, making it more suitable for operation in textile industry, small conveyor belt, tracked robot etc. However, the use of rare-earth permanent magnets (PM) in such motors, while possessing desirable properties, comes with a high cost, limiting its widespread industrial application. In this paper, a less rare-earth flux reversal permanent magnet (FRPM) motor with integer slot distributed winding is proposed, which can significantly improve the utilization ratio of PM material. An orthogonal modulation analysis method is proposed to clarify the operation principle of the proposed FRPM motor. Utilizing this method, the harmonic distributions of radial and tangential magnetic fields generated by PM material and armature current can both be derived. Additionally, employing maxwell tensor method, the torque generated by each harmonic is calculated, which verifies that the static fundamental harmonic can also generate the main output torque. Furthermore, the multi-objective genetic algorithm method is applied to optimize the parameters. Three existing PM motors, namely one flux-switching PM motor and two conventional FRPM motors, are used to compare with the proposed motor. The results indicate that the proposed motor can reach higher torque with less PM consumption. Finally, a prototype is processed and tested to validate the correctness of the design and analysis.

Design of A High Torque Density Motor Based on Halbach Array Integral Ring Rotor

Optimized Design of High Torque Density Permanent Magnet Synchronous Motor with Halbach Magnet

Development of Integrated Hydrostatic-Driven Electric Generator

Design and Fem Analysis of A High Efficiency Axial-Flux Brushless Dc Motor for Flywheel System

Analysis of Dual-Armature Flux Reversal Permanent Magnet Machines with Halbach Array Magnets

Design Optimization with Outer Rotor Interior Permanent Magnet Synchronous Motor with Hybird Permanent Magnet

Design and Analysis of a 500W 120000rpm High-Speed Permanent Magnet Motor

Design and Analysis of a New Hybrid Excitation Vernier Motor with Reduced Permanent Magnet

Design and Analysis of Outer Rotor Permanent-Magnet Vernier Machines with Overhang Structure for In-Wheel Direct-Drive Application

A New Flux-Concentrating Rotor of Permanent Magnet Motor for Electric Vehicle Application

Design and Performance Analysis of Dual-Stator Brushless Doubly-Fed Machine with Cage-Barrier Rotor

Design of an Actuator for Biped Robots Based on the Axial Flux Motor.

Design of a Novel PM Motor with Hybrid Magnetized IPM External Rotor for In-wheel Drive Application

Design and Optimization of Halbach-Array PM Rotor for High-Speed Axial-Flux Permanent Magnet Machine With Ironless Stator

Design and Cogging Torque Reduction of Radial Flux Brushless DC Motors with Varied Permanent Magnet Pole Shapes for Electric Vehicle Application

Study on the Influences of an Outer-Coreless-Rotor Permanent Magnet Synchronous Machine Using Halbach Magnet Array

Design of High-speed High Power Density Single-phase Permanent Magnet Brushless DC Motor Considering Control Performance

Study on Process Derivation and Characteristic Analysis for BLDC Motor Design Using Dual Rotor Structure with High Torque Density

Design and Investigation of Flux-Reversal Permanent-Magnet Motor with Less Rare-Earth Magnet for Low-Cost Application

Torque Improvement of Dual-Rotor Coreless Stator AFPM Machine With Non-Overlapping Concentrated Winding for Counter-Rotating Ducted Fan Application

Research on a Novel Transverse Flux Permanent Magnet Motor With Hybrid Stator Core and Disk-Type Rotor for Industrial Robot Applications