Abstract:Based on its availability, cost and stability, rechargeable Mg batteries (RMBs) are potential candidates to fulfill the futuristic demand for high energy density storage devices. However, they are minimally explored due to sluggish Mg ion diffusion in cathode materials. Literature suggests that the Chevrel phase (Mo6S8) holds promise as a cathode (positive electrode) for RMBs due to its open structure and self-healing property during cycling. This study reports the electrochemical performance of Mo6S8 (synthesized using cost effective precursors (Cu-Mo-MoS2)) as a cathode for rechargeable Mg batteries for the first time. The development of Mo6S8 is a two-step process: (i) synthesis of Cu2Mo6S8 via high energy milling method using Cu, Mo and MoS2 as precursors and (ii) leaching of Cu from Cu2Mo6S8. The morphological and structural characteristics of developed materials are recorded using XRD and FESEM. The developed Mo6S8 is cuboid-shaped with a rhombohedral unit cell. To record the electrochemical performance of Mo6S8 as a positive electrode for RMBs, CR2016 type half-cells are fabricated. It is observed that the initial discharge capacity was 89 mAhg-1 at a current density of 25 mAg-1 (1C = 128 mAg-1). Interestingly, capacity increases from 89 to ≈100 mAhg-1 during 50 cycles which is higher than reported literature. The coulombic efficiency of ≈90% is observed for 100 cycles. Additionally, the over-potential decreases with an increase in cycle number. Importantly, authors explained the diffusion behavior of Mg ions in Mo6S8 with 0.4 M 2(PhMgCl)-AlCl3/THF (APC) electrolyte. The diffusion coefficients have been calculated in the range of 10-8-10-14 cm2s-1. Also, authors explain the effect of outer site activation during cycling on the diffusion kinetics of the materials using GITT technique. This investigation of diffusion kinetics of Mg ion in Mo6S8 may pave the way for evaluating various Chevrel phases as electrode material for future rechargeable magnesium battery system.

Iodine Vapor Transport-Triggered Preferential Growth of Chevrel Mo6S8 Nanosheets for Advanced Multivalent Batteries.

Two-dimensional Molybdenum Nitride Nanosheets Modified Celgard Separator with Multifunction for LiS Batteries

Chevrel Phase Mo<sub>6</sub>S<sub>8</sub> Nanosheets Featuring Reversible Electrochemical Li‐Ion Intercalation as Effective Dynamic‐Phase Promoter for Advanced Lithium‐Sulfur Batteries

Rational Design of Moo2−Based Electrodes by Crystal Surface Engineering Control for Ultra-Long Life Sodium Ion Batteries

Chevrel Phase Mo6 T8 (T = S, Se) as Electrodes for Advanced Energy Storage.

Cation-synergy stabilizing anion redox of Chevrel phase Mo6S8 in aluminum ion battery

Non-destructive Chemical Prelithiation of VO2(B) Anodes Constructing a Multifunctional Interphase Layer for Advanced Li-Ion Batteries

In-situ TEM Experiments and First-Principles Studies on the Electrochemical and Mechanical Behaviors of Α-Moo3 in Li-ion Batteries

Chevrel Phase Mo6S8 Nanosheets Featuring Reversible Electrochemical Li‐Ion Intercalation as Effective Dynamic‐Phase Promoter for Advanced Lithium‐Sulfur Batteries

Chevrel Phase Mo 6 S 8 Nanosheets Featuring Reversible Electrochemical Li-Ion Intercalation as Effective Dynamic-Phase Promoter for Advanced Lithium-Sulfur Batteries.

Boosting aqueous zinc-ion storage in MoS2 via controllable phase

Interfacial Reinforcement Structure Design Towards Ultrastable Lithium Storage in MoS2-based Composited Electrode

Reversible Electrochemical Anionic Redox in Rechargeable Multivalent-Ion Batteries

Salt-Templating Protocol to Realize Few-Layered Ultrasmall Mos2 Nanosheets Inlayed into Carbon Frameworks for Superior Lithium-Ion Batteries

Valence Modulation and Morphological Engineering of MoO 3 as High−performance Cathode for Aqueous Zinc Ion Batteries

Artificially Interconnected Ion-Diffusion Nanochannels in Ion-Indiffusible Phase-Conversion Cathodes for Rechargeable Aqueous Zinc Batteries

MoS2 Nanosheet Assembling Superstructure with a Three-Dimensional Ion Accessible Site: A New Class of Bifunctional Materials for Batteries and Electrocatalysis

Electrochemical studies and diffusion kinetics in Chevrel phase (Mo6S8) for rechargeable Mg batteries

Enhanced Al‐Storage Performance by Electronic Properties Optimization and Structural Customization in MOF‐Derived Heterostructure

Preparation of large layer spacing bimetallic sulfide hollow nanosphere for high-energy battery system application

Selective Preparation of 1T-and 2H-Phase MoS2 Nanosheets with Abundant Monolayer Structure and Their Applications in Energy Storage Devices