Abstract:Tailoring energy band structure of bismuth oxychloride (BiOCl)-based photocatalysts by virtue of the metal and/or non-metal elements is one of the promising strategy to address environmental issues, especially plays a crucial role in water remediation. However, it still remains a great challenge to balance the light-harvesting and charge carriers separation. Herein, a feasible strategy was proposed for the simultaneous integration of energy-band modulation and surface hydroxylation to alleviate the as-mentioned contradiction and long-standing issues. By using a simple one-pot hydrothermal method, In-S-co-doped BiOCl photocatalyst coupling with surface hydroxylation (denoted as In/BOC-S-OH) was prepared by the simultaneous co-precipitation and ripening process and exhibited a good photocatalytic activity for removing tetracycline (TC) under visible light-irradiation than the counterparts of In-doped BiOCl (In/BOC), S-doped BiOCl (In/BOC-S) or surface -OH modification BiOCl (In/BOC-OH). Such satisfied photocatalytic efficiency benefits from the synergistic effect on the visible light capture, charge migration and separation associated with the introduction of intermediate energy levels and surface defect, respectively. Accompanying with the introduction of In and S hetero-atoms intercalation, both the potentials of valence and conduction bands were adjusted and the reduction of the bandgap could promote the capture of photons. Meanwhile, the powerful polarization effect associated with the non-uniform charge distribution could promote the special separation of carriers. More importantly, the surface defects induced by hydroxylation could act as traps for photogenerated electrons to stimulate the rapid separation of carriers, thereby causing the cleavage of antibiotics on the catalytic surface. This research offers a reliable strategy and promising scheme via effective solar energy conversion and charge carrier separation to advance photocatalytic wastewater remediation.

Photo-sensitization of BiOCl by CuInS2 Surface Layer for Photoelectrochemical Cathode

Highly Efficient 2D/3D Structured CuCo2S4/CdIn2S4 Composites with a P–n Heterojunction for Boosting Photocatalytic Hydrogen Evolution

Synthesis of a Cu2O/Carbon Film/NiCoB‐Grpahene Oxide Heterostructure As Photocathode for Photoelectrochemical Water Splitting

Highly efficient 3D/0D CdIn2S4/Cu2O photoanode with p-n type heterojunction for boosted photoelectrochemical water splitting under visible light irradiation

In situ synthesized In2O3/CuBi2O4 heterojunction photocathodes for efficient photoelectrochemical water splitting

Preparation of CuBi2O4 Photocathodes for Overall Water Splitting under Visible Light Irradiation

Co-optimization of CuBi2O4 photocathode by heterojunction and hole-selective layer for efficient photoelectrochemical water splitting

General In Situ Photoactivation Route with IPCE over 80% toward CdS Photoanodes for Photoelectrochemical Applications

The CuSCN layer between BiVO4 and NiFeOx for facilitating photogenerated carrier transfer and water oxidation kinetics

Designed composite catalysts of Cu-doped BiOCl nanosheets on CuFe-PBA cubes for enhanced photoelectrochemical H 2 evolution activity in neutral medium

Unveiling the Dual Impact of CuI Layer and Se Content in Sb2(S, Se)3 Photocathodes for Solar Water Splitting

Fabrication of In-S-co-doped two-dimensional BiOCl coupling with surface hydroxylation toward simultaneously efficient charge separation and redox capability for photocatalytic water remediation

Tuning Surface Electronics State of P-Doped In2.77S4/In(OH)3 Toward Efficient Photoelectrochemical Water Oxidation.

Interfacial Bi–S bonds modulate band alignment for efficient solar water oxidation

Design and In Situ Growth of Cu 2 O‐Blended Heterojunction Directed by Energy‐Band Engineering: Toward High Photoelectrochemical Performance

Synthesis and improved photoelectrochemical performances of Bi9O7.5S6/CdS heterojunction

Epitaxial grown [hk1] oriented 2D/1D Bi2O2S/Sb2S3 heterostructure with significantly enhanced photoelectrochemical performance

Interfacial Phosphate Like "Bridge" Mediates Bulk Charge and Surface Oxygenated-Intermediates Migration for Efficient Photoelectrochemical Water Splitting

Type-II Heterojunction CdIn2S4/BiVO4 Coupling with CQDs to Improve PEC Water Splitting Performance Synergistically

Bismuth Oxyhalide-Based Materials (BiOX: X = Cl, Br, I) and Their Application in Photoelectrocatalytic Degradation of Organic Pollutants in Water: A Review

Nonstoichiometric In–S Group Yielding Efficient Carrier Transfer Pathway in In2S3 Photoanode for Solar Water Oxidation