Abstract:Shanghai Soft-Xray FEL (SXFEL) test facility was designed and built to demonstrate EEHG and HGHG schemes and verify key technologies for the future hard xray FEL facility (SHINE). After three years commissioning 8.8 nm FEL radiation with peak power of 1 MW had been achieved at the end of 2019. The design, fabrication, commissioning and operation of BI system including striplineBPM, Cavity-BPM, screen monitor, bunch length monitor, beam arrival monitor, bunch energy monitor, will be introduced in this paper. Several lessons learned during design stage and beam commissioning stage, such as radiation damage of CCDs and step-motors, bad choice of CBPM working frequency, thermal drift of BAM and so on, will be addressed as well. INTRODUCTION SXFEL Test Facility (SXFEL-TF) was initiated in 2006 and founded in 2014. Its 0.84GeV linac and undulators were installed through 2016 to 2018, it is for testing the cascaded seeding schemes. The main parameters are listed in Table 1. The SXFEL-TF commissioning has completed this year, and the SXFEL user facility (SXFEL-UF) is under construction. The layout of SXFEL-TF and SXFEL-UF are shown in Figure 1. Table 1: SXFEL-TF Parameters Parameter Value Total length 293m Electron energy 0.84 GeV Bunch charge 0.5 nC Repetition rate 10 Hz FEL output 8.8 nm FEL scheme HGHG/EEHG FEL pulse 100-200 fs FEL power >100 MW Figure 1: Layout of SXFEL-TF (top) and SXFEL-UF (bottom). In order to maintain high FEL gain, high performance beam instrumentation system is required for the SXFELTF. Measured beam parameters including bunch charge, beam position (BPM), beam profile, beam arrival time (BAM) and bunch length (BLM). Table 2 lists the beam diagnostic devices included and the required resolution. Table 2: Requirements of SXFEL-TF Diagnostic System

Photon-in/photon-out Endstation for Studies of Energy Materials at Beamline 02B02 of Shanghai Synchrotron Radiation Facility

Applications for Synchrotron Radiation in Inertial Confinement Fusion Research

Soft X-Ray Spectroscopic Endstation At Beamline 08u1a Of Shanghai Synchrotron Radiation Facility

Beam instrumentation system for shanghai soft x-ray fel test facility*

An APXPS endstation for gas–solid and liquid–solid interface studies at SSRF

Calibrasion of the energy response for the soft x-ray detections elements with the beijing- synchrotron radiation facility

Calibration of Soft X-Ray Detection with Synchrotron Radiation

Design of an Ultrahigh-Energy-Resolution and Wide-Energy-Range Soft X-Ray Beamline

Design of the New Soft X-ray Beamline for in Situ Analysis of Energy Materials at National Synchrotron Radiation Laboratory

Performance of the Atomic and Molecular Physics Beamline at the National Synchrotron Radiation Laboratory.

An endstation for resonant inelastic X-ray scattering studies of solid and liquid samples

High-resolution ARPES endstation for in situ electronic structure investigations at SSRF

Design and Performance of Bending-Magnet Beamline BL02B at the SSRF

Development and commissioning of a broadband online X-ray spectrometer for the SXFEL Facility

A new experimental station for microbeam X‐ray scattering at the SSRF BL10U1 beamline

A New Mobile Grazing-Incidence X-ray Absorption Fine Spectroscopy Endstation at Beijing Synchrotron Radiation Facility

High-performance soft x-ray spectromicroscopy beamline at SSRF.

The soft X‐ray spectromicroscopy beamline BL08U1A upgrade at SSRF

A facility for the analysis of the electronic structures of solids and their surfaces by synchrotron radiation photoelectron spectroscopy

Designing a pulse-resolved photon diagnostic system for Shanghai SXFEL

A SMALL-ANGLE X-RAY SCATTERING STATION AT BEIJING SYNCHROTRON RADIATION FACILITY