Abstract:Purpose – Rock-fill dams are embankments of compacted free-draining granular earth containing an impervious zone. Earth utilized in such dams often contains a high percentage of large particles – hence the term rock-fill. Mass stability of these dams results from friction and particle interactions rather than through a cementing agent binding the particles together. However, high-stress conditions and prolonged exposure to the elements can severely damage rock-fill. Therefore, understanding and modeling rock-fill breakage is important for dam engineering. The purpose of this paper is to improve discontinuous deformation analysis (DDA) techniques for modeling rock-fill breakage, proving the new method using simulations of spherical particle crushing. Design/methodology/approach – This work models rock-fill as bonded ellipsoid particles, and develops an improved DDA method to model the breakage of particle assemblies. The paper starts by describing the principles of three-dimensional DDA for spherical particles, and then derives the submatrices for normal contact, shear contact, and frictional force. The new algorithm incorporates a bond model with a revised open-close iteration algorithm into the DDA method to simulate particle crushing. To validate the improved DDA method, calculated particle contacts and movements are validated against theoretical results. Finally, this work performs a series of point-loading experimental tests for cement ellipsoid particles of both high and low compression strengths, with the test results compared against the results from corresponding DDA simulations. Findings – In particle crushing tests, the force and displacement show an approximately linear relationship until the crushing point, at which point low compression ellipsoid particles split into several large pieces while the high-compression particles break into many small fragments. The DDA simulation results are in good agreement with the crushing tests, demonstrating the validity of the DDA method for solving particle crushing problems. Although the improved DDA model is applicable to rock-fill particle crushing studies, some issues remain, particularly in increasing calculation efficiency and performing large-scale computations and long real-time simulations. Future research should address these issues. Originality/value – A bond model with a revised open-close iteration algorithm is incorporated into the DDA method. The simulated results shed insight into rock-fill crushing mechanisms, an element of concern in engineering practices.

Improvements in DDA Program for Rockslides with Local In-Circle Contact Method and Modified Open-Close Iteration

Extended DDA with Rotation Remedies and Cohesive Crack Model for Simulation of the Dynamic Seismic Landslide

Improved friction force calculation with an augmented open-close iteration formulation in discontinuous deformation analysis

Development of Discontinuous Deformation Analysis with Displacement-Dependent Interface Shear Strength

Improved Discontinuous Deformation Analysis Method for Modeling Tensile Cracking in Quasi-Brittle Materials

Remedies for Distortion and False Volume Expansion Problems with Large Rotation in Discontinuous Deformation Analysis

Modeling Rock Failure Using the Numerical Manifold Method Followed by the Discontinuous Deformation Analysis

Advances in Two-Dimensional Discontinuous Deformation Analysis for Rock-Mass Dynamics

Improvement of DDA with a New Unified Tensile Fracture Model for Rock Fragmentation and its Application on Dynamic Seismic Landslides

Runout simulation of seismic landslides using discontinuous deformation analysis (DDA) with state-dependent shear strength model

Improvement of Contact Calculation in Spherical Discontinuous Deformation Analysis

Numerical simulation of wedge failure of rock slopes using three-dimensional discontinuous deformation analysis

An Improved Three-Dimensional Spherical DDA Model for Simulating Rock Failure

CPU-accelerated Explicit Discontinuous Deformation Analysis and Its Application to Landslide Analysis

Particle Crushing Simulations with Improved Discontinuous Deformation Analysis

Simulation of the Nonlinear Mechanical Behaviors of Jointed Rock Masses Based on the Improved Discontinuous Deformation and Displacement Method

Latest Advances in Discontinuous Deformation Analysis Method

Study on large rotation problem of a block in discontinuous deformation analysis

Extension of Two-Dimensional DDA on Co-Seismic Slope Stability Analysis Considering Dynamic Shearing Strength

Rock Slope Stability and Stabilization Analysis Using the Coupled DDA and FEM Method: NDDA Approach

Three-Dimensional Discontinuous Deformation Analysis of Failure Mechanisms and Movement Characteristics of Slope Rockfalls