Abstract:A kinetic study on the ignition process of n‐heptane/ammonia mixtures. Only temperature has a significant effect on ignition delay times at all research conditions; the range of significant effects of equivalence ratio and pressure is very narrow. The increase of temperature in the early and middle stages is mainly contributed by the oxidation of n‐heptane, while the increase of temperature in the middle and late stages is mainly contributed by the oxidation of ammonia. Pilot‐ignited ammonia‐fueled engines have drawn more and more attention for low carbon emissions compared to traditional diesel engines. The ignition processes of NH3/NC7H16 mixtures under compression ignition engine‐like conditions are numerically investigated. By comparing the ignition delay times (IDTs) calculated by six ammonia mechanisms with experimental data, the Glarborg mechanism is selected. Then, the Glarborg mechanism and the Zhang detailed n‐heptane mechanism are merged into a new mechanism, which is adopted in the present study. Results show that the negative temperature coefficient behavior of the IDTs is only observed as the ammonia mass fraction is 70%. Only temperature has a significant effect on IDTs at all research conditions, and the effect of ammonia mass fraction is significant when the temperature is lower than 1000 K. However, the effects of equivalence ratio and pressure are small, especially at high temperatures, high equivalence ratios, and high pressures. Interestingly, the IDTs are categorized into three regions by temperature and ammonia mass fraction. The sensitivity analysis indicates that the sensitivity coefficients of most reactions associated with ammonia decrease with a decrease in ammonia mass fraction, whereas only R4210 is sensitive to ammonia mass fraction for n‐heptane‐related reactions. Rates of production and consumption (ROP) analyses indicate that the ammonia mass fraction mainly affects the ROPs of NC7H16, NH3, and NNH at low and medium temperatures, whereas the ammonia mass fraction affects the ROP of H2NO before the temperature of 2000 K. The ROPs of NC7H16, NH3, and NNH significantly increase with increasing temperature, whereas the ROP of H2NO slightly increases with increasing temperature. The increase of temperature in the early and middle stages is mainly contributed by the oxidation of n‐heptane, while the increase of temperature in the middle and late stages is mainly contributed by the oxidation of ammonia.

Quantitative Study on Chemical Effects of Actual/simulated Recirculated Exhaust Gases on Ignition Delay Times of N-Heptane /ethanol Fuel Blends at Elevated Temperature

A Rapid Compression Machine Study of Autoignition, Spark-Ignition and Flame Propagation Characteristics of H2/CH4/CO/air Mixtures

Computational Study on the Impact of Gasoline-Ethanol Blending on Autoignition and Soot/NOx Emissions under Gasoline Compression Ignition Conditions

Experimental studies on combustion and emissions of RCCI (reactivity controlled compression ignition) with gasoline/n-heptane and ethanol/n-heptane as fuels

Computational study on the impact of gasoline-ethanol blending on autoignition and soot/NOx emissions under low-load gasoline compression ignition conditions

Investigating Auto-Ignition Behavior of N-Heptane/iso-octane/ethanol Mixtures for Gasoline Surrogates Through Rapid Compression Machine Measurement and Chemical Kinetics Analysis

Study of Exhaust Gas Composition and Dilution Effects on Diesel Spray Ignition Characteristics

Three-Dimensional Simulation Analysis of the Effect of Hydrous Ethanol and Exhaust Gas Recirculation on Gasoline Direct Injection Engine Combustion and Emissions

Experimental and Numerical Study on Autoignition Characteristics of the Gasoline/Diesel/Ethanol and Gasoline/Diesel/PODE/Ethanol Fuels

Effects of low-carbon high-reactivity fuels on combustion and emission characteristics in a part-load condition of a DICI engine

Experimental Study of the Impact of Ethanol Content On Partially Premixed Combustion with Ethanol-Gasoline Blends

Influence of EGR compounds on the oxidation of an HCCI-diesel surrogate

Experimental and modeling study of ignition delay times of n-C5H12 and C3H6 under O2/CO2 atmospheres

Kinetic study of ignition process of ammonia/n‐heptane fuel blends under engine conditions

Impact of Nitric Oxide (NO) on N-Heptane Autoignition in a Rapid Compression Machine

Effect of various ethanol/diesel cosolvents addition on combustion and emission characteristics of a CRDI heavy diesel engine

Effects of Combustion Parameters on Emissions of Diesel Diesel/n-Butanol, and Diesel/n-Butanol/2-Ethylhexyl Nitrate Fuels at Different Intake-Oxygen Concentrations in a Diesel Engine

Experimental study of effects of exhaust gas recirculation and combustion mode on combustion, emission, and performance of DME‐methanol ‐fueled turbocharged c ommon‐rail engine

Experimental and Computational Investigation of the Influence of Ethanol on Auto-ignition of n-Heptane in Non-Premixed Flows

Effect of turbulent mixing on the end gas auto-ignition of n-heptane/air mixtures under IC engine-relevant conditions

Effects of Intake Components on Combustion and Emission Characteristics in an n -Butanol/Diesel Blend Fueled Engine