Dynamic Voltage Stiffness Control Technique for a Virtual Oscillator based Grid-forming Controller
Ritwik Ghosh,Narsa Reddy Tummuru,Bharat Singh Rajpuohit
DOI: https://doi.org/10.1109/tie.2023.3288186
IF: 7.7
2023-01-01
IEEE Transactions on Industrial Electronics
Abstract:Voltage stiffness is a vital parameter for grid-forming inverters. With a very high voltage stiffness, an inverter picks up all the reactive power demands of the Point of Common Coupling (PCC). In contrast, with a very low voltage stiffness, the inverter does not participate in voltage regulation at all. Hence, any grid-forming controller should be able to control voltage stiffness dynamically. Virtual Oscillator based Controllers (VOCs), the latest and most advanced grid-forming controllers, provide all the steady-state functionalities of conventional droop controllers and, in addition, time-domain synchronization with a connected network. However, existing VOCs cannot control voltage stiffness dynamically. As a result, limiting reactive power output during a higher voltage sag, especially when connected to a weak grid, is challenging for VOCs. The only existing solution for a VOC in such conditions is to enter into current control mode, which leads to ineffective synchronization, output power oscillation, and, finally, inefficient grid-forming operation. Integrating a dynamic voltage stiffness controller inside a VOC is not as straightforward as a droop controller. Because, unlike phasor-based droop controllers, VOCs have time-domain implementation. This article introduces Virtual Impedance (VIm) based dynamic voltage stiffness control technique for VOCs with systematic design procedures and rigorous stability analysis.
automation & control systems,engineering, electrical & electronic,instruments & instrumentation