Abstract:In this paper we present an all-fiber directly pumped fiber laser in master oscillator power amplifier configuration based on domestically manufactured fibers. In the amplifier stage of the laser, the gain fibers adopt the 20/400 μm Yb-doped double cladding fibers manufactured separately by Wuhan Fiber Home Technologies Group and China Electronics Technology Group Corporation No. 46 Research Institute in two individual experiments. Via this homemade amplifier stage, the system achieves a 1080 nm fiber laser with output powers of 3050 W and 3092 W respectively with two types of fibers. When the gain fiber of the amplifier adopts the YDF manufactured by Wuhan Fiber Home Technologies Group, the corresponding extraction efficiency and the optical-to-optical efficiency reach 67.3% and 63.0% respectively. No residual pump laser is found in the spectrum of output laser, and the beam quality is measured to be M2<2. Similarly, when the gain fiber of the amplifier adopts the YDF manufactured by China Electronics Technology Group Corporation No. 46 Research Institute, the corresponding extraction efficiency and the optical-to-optical efficiency reach 68.2% and 63.9% respectively. To the best of our knowledge, this is the best result ever reported for directly pumped all-fiber laser. Meanwhile, as we use the domestically manufactured fiber as the gain fiber in the amplifier stage, the result verifies the usage of homemade active fibers in 3-kilowatt level fiber laser. By combining the results of the high power fiber laser, the low efficiency of domestic fiber laser in our experiment might be explained to be due to defects in fiber manufacturing process, the inhomogeneous refractive index of the core, structural flaw of the homemade fiber observed by the microscopic images of the cross section and the splicing fuse of homemade fibers. The main difficulty of these two experiments lies in the heat dissipation of the gain fiber in the amplifier stage. Also, due to the restriction of experimental condition, photodarkening test is unable to run for a longer period of time, which is the focus of our further work. Therefore, measures such as refining fiber manufacturing techniques, increasing pump power and optimizing the length of fiber are suggested to be taken in order to obtain a higher output power from homemade fiber laser.

Investigation on the Performance of a Homemade Thulium-Doped Fiber Laser Oscillator

Study on High-Power Narrow-Bandwidth 1 915 Nm Thulium-Doped Fiber Laser

Optimization and Application of High Power Thulium-Doped Fiber Laser

1.75‐Kilowatt continuous‐wave output fiber laser using homemade ytterbium‐doped large‐core fiber

3000 W Direct-Pumping All-Fiber Laser Based on Domestically Produced Fiber

Novel constant-cladding tapered-core ytterbium-doped fiber for high-power fiber laser oscillator

150-W Tm3+-Doped Fiber Lasers With Different Cooling Techniques And Output Couplings

Optimal Design of High Energy Similariton Thulium-Doped Fiber Lasers

Analysis of Gain Distribution in Cladding-Pumped Thulium-Doped Fiber Laser and Optical Feedback Inhibition Problem in Fiber-Bulk Laser System

Thulium-doped fiber laser with bidirectional output in a ring laser cavity

Experimental Investigation Of Gamma-Ray Irradiation Effect On Tm-Doped Fibers

A 110-W Fiber Laser with Homemade Double-Clad Fiber

Single Longitudinal Mode Narrow Linewidth Thulium-Doped Fiber Laser Based on a Eye-Shaped Dual-Ring Filter

Ultra-short Wavelength Operation in Thulium-doped Silica Fiber Laser with Bidirectional Pumping

A Theoretical and Experimental Investigation of an In-Band Pumped Gain-Switched Thulium-Doped Fiber Laser

All Fiber Gain-Switched Thulium-Doped Fiber Laser Pumped by 1.558μm Laser

Wavelength-Switchable 2 μm Single-Longitudinal-Mode Thulium-Doped Fiber Laser Based on Dual-Active Cavity and DLTCTR

Wavelength-tunable Thulium-Doped Fiber Laser by Employing a Self-Made Fabry–Perot Filter

Ultra-narrow linewidth Tm<sup>3+</sup>-doped fiber laser based on intra-core fiber Bragg gratings

2.05 Μm High-Energy Thulium-Doped Fibre Amplifier Based on Backward Pumping

400 Mw Narrow Linewidth Single-Frequency Fiber Ring Cavity Laser in 2 Um Waveband