Abstract:The accuracy of a machining model depends on the capability of this model to describe the physical phenomena associated to the real machining system. This includes the material constitutive model and the approach used to describe the field flow of the material in cutting. In this paper, a model of high speed machining (HSM) of Ti6Al4V titanium alloy is developed. This cutting model includes the proposed constitutive model considering the influence of strain hardening, strain-rate, temperature, and state of stress (e.g., stress triaxiality and Lode parameter) in the material plasticity and damage. Finite Element Method (FEM) using Coupled EulerianLagrangian (CEL) approach is used to simulate the cutting model. A sensitivity analysis of the influence of the mesh topography on the chip geometry and cutting force is performed resulting in the determination of the optimal element size and element orientation. Simulation results obtained using the CEL approach are compared with those obtained using the Lagrangian one. Moreover, simulated cutting force and chip geometry obtained using the proposed constitutive model are compared with those obtained using the Johnson-Cook (J-C) model, and experimental data. Both chip geometry and cutting force predicted by the proposed constitutive model is closer to the experimental one than the J-C constitutive model. The CEL approach combined with the proposed constitutive model can simulate material side flow, which results in a larger width of chip compared to the width of cut, and in the formation of lateral burr on the workpiece. It also permits simulating the cyclic variation of the plastic strain and topography of the machined surface along the cutting direction, observed experimentally.

Smooth Particle Hydrodynamics Modeling of Cutting Force in Milling Process of TC4

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

Numerical Simulation Study on Milling Force for Aerospace Aluminum Alloy

Simulation of 3d Chip Shaping of Aluminum Alloy 7075 in Milling Processes

Simulation of the Orthogonal Cutting of Ofhc Copper Based on the Smoothed Particle Hydrodynamics Method

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Simulation of the Cutting Sequence of AISI 316L Steel Based on the Smoothed Particle Hydrodynamics Method

Finite Element Simulation of Titanium Alloy Milling Process

Analytical Model of Cutting Force in Axial Ultrasonic Vibration-Assisted Milling In-Situ TiB2/7050Al PRMMCs

Cutting Force Prediction for Milling Titanium TC11

Study on Numerical Simulation and Experiment of Titanium Alloy for High Speed Milling

Simulation of Effect of Milling Parameters on Milling Force in High-Speed Milling of Titanium Alloy TC4

Simulation of Material Side Flow Using a 3D Coupled Eulerian-Lagrangian Approach and a Constitutive Model Considering the Stress State

Experimental Research of Milling Force and Surface Quality for TC4 Titanium Alloy of Micro-Milling

Modeling of Orthogonal Cutting Process of A2024-T351 with an Improved SPH Method

The Simulation of Cutting Force and Temperature in High-Speed Milling of Ti-6Al-4V

Finite Element Simulation and Experimental Research on Micro-Milling Process of Titanium Alloy

Machining Simulation of Ti6Al4V Using Coupled Eulerian-Lagrangian Approach and a Constitutive Model Considering the State of Stress

MPM Simulations of High-Speed and Ultra High-Speed Machining of Titanium Alloy (ti–6al–4v) Based on Fracture Energy Approach

Investigating the Effect of Cutting Parameters of Ti–6Al–4V on Surface Roughness Based on a SPH Cutting Model