[Rapid Achievement of Nitrifying Micro-granular Sludge and Its Nitritation Function].

Wen-Ru Liu,Jia-Jun Song,Jian-Fang Wang,Yao-Liang Shen

DOI: https://doi.org/10.13227/j.hjkx.201907158

2020-01-01

Abstract:The rapid achievement of nitrifying micro-granular sludge and its nitritation function was studied in a continuously operated internal-loop airlift reactor seeding with floccular sludge. Results showed that the sludge micro-granulation was almost realized within three weeks by gradually reducing the hydraulic retention time from 5 h to 2.5 h. The color of the sludge first changed from yellowish-brown to creamy white, and then changed to pale yellow during the micro-granulation process. The settleability of the sludge first changed from good to bad, and then recovered to good. The value of the sludge settling velocity (SV) at SV5 and SV30 were both equal to 4%-5%, while SVI30 and SVI5 were both around 12-13 mL·g-1. The average size of the obtained nitrifying micro-granular sludge was 134 μm on day 27. Nearly 70% of the nitrifying micro-granular sludge was maintained in a relatively narrow range of 59-163 μm, thus indicating the largely homogeneous diameter distribution of these micro-granules. After sludge micro-granulation, the nitritation function was achieved within one week by progressively increasing the influent NH4 concentrations from 50 mg·L-1to 200 mg·L-1. The NO2- accumulation ratio and the nitritation loading rate reached up to 90% and 1.34 kg·(m3·d)-1, respectively. The high level of residual NH4 concentration in the effluent, or the low ratio of dissolved oxygen (DO) to NH4+-N concentrations (0.03-0.09), should be the primary cause of the rapid achievement of nitritation in the micro-granular sludge reactor.