Abstract:This paper studies the transmit energy beamforming in a multi-antenna wireless power transfer (WPT) system, in which an access point (AP) equipped with a uniform linear array (ULA) sends radio signals to wirelessly charge multiple single-antenna energy receivers (ERs). Different from conventional energy beamforming designs that require the AP to acquire the channel state information (CSI) via training and feedback, we propose a new training-free energy beamforming approach assisted by wireless radar sensing, which is implemented based on the following two-stage protocol. In the first stage, the AP performs wireless radar sensing to estimate the path gain and angle parameters of the ERs for constructing the corresponding CSI. In the second stage, the AP implements the transmit energy beamforming based on the constructed CSI to efficiently charge these ERs in a fair manner. Under this setup, first, we jointly optimize the sensing beamformers and duration in the first stage to minimize the sensing duration, while ensuring a given accuracy threshold for parameters estimation subject to the maximum transmit power constraint at the AP. Next, we optimize the energy beamformers in the second stage to maximize the minimum harvested energy by all ERs. In this approach, the estimation accuracy threshold for the first stage is properly designed to balance the resource allocation between the two stages for optimizing the ultimate energy harvesting performance. Finally, numerical results show that the proposed training-free energy beamforming design performs close to the performance upper bound with perfect CSI, and outperforms the benchmark schemes without such joint optimization and that with isotropic transmission.

A Fast-Beamforming Technique for Blind-Adaptive Wireless Power Transfer Towards Free-Flying Insects.

Distributed Beamforming Based Wireless Power Transfer: Analysis and Realization

Training-Free Energy Beamforming Assisted by Wireless Sensing

Cross Power Spectral Density Based Beamforming for Underwater Acoustic Communications

Beamforming Design for Integrated Sensing and Wireless Power Transfer Systems

RIS-aided Wireless Power Transfer for Unmanned Aerial Vehicles

A 116.4 Mg Wireless Ultra-Lightweight Microstimulator for Cyborg Bees

A Current-Switching Communication Technique for Miniaturized Medical Implants

Hardware Impairment-Aware Data Collection and Wireless Power Transfer Using a MIMO Full-Duplex UAV

A Reconfigurable Active Beamforming Array for Biomedical Radar Applications

Energy-Efficient Data Collection and Wireless Power Transfer Using A MIMO Full-Duplex UAV

Enhancing Wireless Information and Power Transfer by Exploiting Multi-Antenna Techniques

Adaptive Blind Beamforming for Intelligent Surface

Sensing-assisted Near-field Energy Beam Focusing with ELAA Over Non-stationary Channels

Design of Ambient Backscatter Training for Wireless Power Transfer

Single-Frequency Self-Alignment RF Resonant Beam for Information and Power Transfer

Adaptively Directional Wireless Power Transfer for Large-scale Sensor Networks

Energy Beamforming for RF Wireless Power Transfer with Dynamic Metasurface Antennas

Design and Implementation of 5.8GHz RF Wireless PowerTransfer System

End-to-End Waveform and Beamforming Optimization for RF Wireless Power Transfer

End-to-End Transmission Analysis of Simultaneous Wireless Information and Power Transfer using Resonant Beam