Abstract:In recent years, hydrogen proton exchange membrane fuel cells have gained growing attention in the heavy duty vehicle (HDV) sector due to lower cost with increased driving range and lower refueling time compared to Li ion battery systems.[1] However, special requirements apply to HDV fuel cells such as long lifetime (25000 – 30000 h) at low Platinum loadings. Additionally, future Pt cathode loadings should be reduced from ≥ 0.4 mg Pt /cm2 (i.e. the current benchmark) to 0.25 mg Pt /cm2 by 2050, while a constant power density of 840 mW/cm2 at 0.769 V should be achieved as defined by the US Department of Energy.[2] Despite Pt nanoparticles finely dispersed on carbon supports are considered the benchmark catalysts, the cathode is yet suffering from several degradation processes such as carbon corrosion, Pt nanoparticle detachment, agglomeration, dissolution and Pt redeposition, hindering the achievement of the aforementioned goals.[3, 4] Therefore, in-depth understanding of the electrocatalyst degradation mechanisms by which Pt losses its catalytic activity is required to develop optimized synthesis methods for stable materials. Recently, we developed novel mesoporous N-doped carbon (MPNC) supports with improved stability against carbon corrosion in comparison to a commercial reference carbon support.[5] Utilizing the advantage of such enhanced stability, we designed Pt/MPNC catalysts for oxygen reduction reaction (ORR) with an extended stability reaching over 10000 cycles in comparison to the commercial Pt/C catalyst, as revealed by the accelerated stress tests (AST) in acidic media and within the carbon corrosion potential range between 1 V and 1.5 V vs RHE. In the present study, we synthesized Pt/MPNC-T catalysts under different reduction temperatures to control the Pt nanoparticle size distribution. We then investigated the impact of the various sizes of the Pt nanoparticles on the stability of Pt/MPNC-T after AST cycles. Therefore, Rotating disc electrode measurements with an established Pt AST protocol using a square wave potential between 0.6 V and 0.95 V vs. RHE over 30000 cycles was applied.[1] The ORR activity, the electrochemical active surface area by H UPD and CO stripping experiments were measured at the beginning of the cycle life test, then after 10000 AST cycles and finally after 30000 AST cycles. The electrochemical measurements before and after AST of the Pt/MPNC-T catalysts were correlated with ex-situ TEM and aberration corrected (AC) STEM data. Experimentally, lower reduction temperature synthesis leads to broader Pt size distributions. Thereby, we noticed the presence of Pt nanoparticles with a diameter between 1 and 3 nm, and smaller Pt entities such as Pt atom clusters and single sites of Pt (i.e. Pt single atoms) at the beginning of cycling. By imaging the surface after 30000 AST cycles, the Pt nanoparticle size substantially increased and the amount of smaller Pt entities was drastically reduced. Such findings indicate that the major degradation process follows the Ostwald ripening mechanism. In conclusion such results reveal the importance of determining the structure-function correlations, which contributes to the general understanding of catalyst degradation processes and allows a knowledge-based optimization of these Pt/MPNC materials in future works. References: [1] D. A. Cullen, K. C. Neyerlin, R. K. Ahluwalia, R. Mukundan, K. L. More, R. L. Borup, A. Z. Weber, D. J. Myers, A. Kusoglu, New roads and challenges for fuel cells in heavy-duty transportation, Nat. Energy 6 (2021) 462–474. [2] J. Marcinkoski, R. Vijayagopal, J. Adams, B. James, J. Kopasz, R. Ahluwalia, Hydrogen Class 8 Long Haul Truck Targets (US Department of Energy, 2019) https://www.hydrogen.energy.gov/pdfs/19006_hydrogen_class8_long_haul_truck_targets.pdf [3] J. Zhao, Z. Tu, S. H. Chan; Carbon corrosion mechanism and mitigation strategies in a proton exchange membrane fuel cell (PEMFC): A review; J. Power Sources 488 (2021) 229434. [4] P. C. Okonkwo, O. O. Ige, E. M. Barhoumi, P. C. Uzoma, W. Emori, A. Benamor, A. M. Abdullah, Platinum degradation mechanisms in proton exchange membrane fuel cell (PEMFC) system: A review, J. Hydrogen Energy 46 (2021) 15850. [5] J. Melke, R. Schuster, S. Möbus, T. Jurzinsky, P. Elsässer, A. Heilemann, A. Fischer, Electrochemical stability of silica templated polyaniline derived mesoporous N-doped carbons for the design of Pt based oxygen reduction reaction catalysts, Carbon 146 (2019) 44–59.

On the Influence of Oxygen on the Degradation of Fe-N-C Catalysts

Spontaneous ORR Activity Drop of Fe-N-C Catalysts upon Atmospheric Storage

Degradation and Regeneration of Fe–Nx Active Sites for the Oxygen Reduction Reaction: the Role of Surface Oxidation, Fe Demetallation and Local Carbon Microporosity

On the Stability of an Atomically‐Dispersed Fe−N−C ORR Catalyst: An In Situ XAS Study in a PEMFC

The Role of Nitrogen Sources and Hydrogen Adsorption on the Dynamic Stability of Fe-N-C Catalysts in Oxygen Reduction Reaction

Hydrogen Peroxide-Induced Overoxidation of Fe-N-C Catalysts: Implications for ORR Activity

Effect of Gas-Phase Nitric Oxide Adsorption on ORR Activity of Fe-N-C Catalysts

Fe–N–C Electrocatalysts’ Durability: Effects of Single Atoms’ Mobility and Clustering

Operando Fe Dissolution in Fe-N-C Electrocatalysts during Acidic Oxygen Reduction and Impact of Local pH Change

Degradation Mechanisms and Durability Improvement Strategies of Fe-N-C Catalysts for Oxygen Reduction Reaction

Operando Fe dissolution in Fe-N-C electrocatalysts during acidic oxygen reduction: impact of local pH change

Nitric Oxide Probe Molecule Studies of Iron-Nitrogen-Carbon PEMFC Oxygen Reduction Reaction Electrocatalysts

Durability Assessment of Transition Metal Oxygen Electroreduction Catalysts with on-Line Flow Cell Trace Elemental Analysis

Spectroscopic Insights into the Nature of Active Sites in Iron–nitrogen–carbon Electrocatalysts for Oxygen Reduction in Acid

Highly efficient and sustainable non-precious-metal Fe–N–C electrocatalysts for the oxygen reduction reaction

Correlative Electrochemical-TEM Study: Probing the Pt Stability of Mesoporous N-Doped Carbon Supported Pt Nanoparticle ORR Electrocatalyst

Architecting FeN x on High Graphitization Carbon for High-Performance Oxygen Reduction by Regulating d-Band Center.

Improving the ORR Performance by Enhancing the Pt Oxidation Resistance

Tuning the thermal activation atmosphere breaks the activity–stability trade-off of Fe–N–C oxygen reduction fuel cell catalysts

In Situ Fe2N@N-doped Porous Carbon Hybrids As Superior Catalysts for Oxygen Reduction Reaction.

Direct Growth of Carbon Nanotubes Doped with Single Atomic Fe–N4 Active Sites and Neighboring Graphitic Nitrogen for Efficient and Stable Oxygen Reduction Electrocatalysis