Abstract:In this article, a dual-linearly polarized endfire antenna is proposed with high gain and stable radiation patterns. A double-sided slot array antenna (DSSAA) and a corrugated rectangular metal strip (CRMS) are employed to realize vertical and horizontal polarization (HP), respectively. Omnidirectional radiation pattern is obtained by etching transverse slots on both sides of the top and bottom metallic plates of a cavity. Based on the double-sided slot antenna, a DSSAA is proposed and fed by an air-substrate parallel strip line (PSL) for stable endfire radiation patterns. Then, the top plate of the DSSAA is reused as a CRMS for HP and compact size. To verify this concept, an all-metal prototype was fabricated and measured. Both the simulation and experimental results show that the DSSAA and the CRMS could offer the highest endfire gains of 12.5 and 12.9 dB, respectively, within a footprint of $3.47\lambda _{0} \times 0.72\lambda _{0} \times 0.13\lambda _{0}$ ( $\lambda _{0}$ is the free-space wavelength at the center frequency). Moreover, an overlapping bandwidth of 7.6% is realized with $\vert S_{11}\vert < -10$ dB, gain variation less than 3 dB. This work may provide useful references for designing dual-polarized endfire antennas with stable radiation patterns, high gain, and compact size.

Microstrip-Fed Endfire Antennas with High Gain and Stable Radiation Pattern

All-Metal Endfire Antenna with High Gain and Stable Radiation Pattern for the Platform-Embedded Application

Microstrip-Fed Surface-Wave Antenna for Endfire Radiation

Endfire Antenna Array Using Microstrip-Fed Cavity-Backed Slot Elements

A Broadband and High-Gain Endfire Antenna Array Fed by Air-Substrate Parallel Strip Line

Planar Microstrip Endfire Antenna with Multiport Feeding

Design of High-Gain Single-Layer Endfire Antenna Using Phase-Reversed Asymmetric Spoof Surface Plasmon Polaritons

Design of a Dual-Linearly Polarized Endfire Antenna

Design Of Wideband Antenna Array With Dielectric Lens And Defected Ground Structure

Design of High-Gain and Small-Aperture Endfire Antenna Using a Phase-Reversal Technique

A Bandwidth-Enhanced Planar Endfire Antenna Based on Surface Waves

Broad Bandwidth Endfire Antenna Using Log-Periodic Directors

Broadband Dual-, Triple-, and Quad-Resonance Endfire Antennas Based on Surface Waves

A Planar Reconfigurable Antenna With Bidirectional End-Fire And Broadside Radiation Patterns

Combination of the Endfire Antenna and Backfire Antenna for Gain Enhancement

Low-Profile High-Gain Endfire Antenna with Circular Polarization

Wideband and Aperture-Efficient Traveling-Wave Endfire Antenna Designs Using the First Higher-Order Transmission Line Mode

Low-Profile Broadband Vertically Polarized Microstrip Magnetic Dipole Antenna With Endfire Radiation

High-Gain Leaky-Wave Endfire Antenna Based on Hansen–Woodyard Condition

Wide Bandwidth Endfire Antenna with Log-Period Directors

Design of A Quasi-Endfire Phased Array