Abstract:With the large-scale development of new energy, the high proportion of wind and solar renewable energy sources and power electronic devices profoundly affect the dynamic behavior of the power system, further posing challenges to the safe and stable operation of the DC system. Traditional ultra-high voltage direct current (UHVDC) engineering converter stations are equipped with a large number of AC filters. During the switching process of AC filters, there is a dead zone of reactive power in the AC/DC system, and there is always a certain amount of reactive power exchange. According to engineering experience, the dead zone range is about 0.8 times the maximum capacity of a single AC filter group. When the AC filter group is large, the reactive power exchange value between the AC/DC systems also increases. Under the continuous development of new energy in the future, the reactive power support capacity of the communication system may become increasingly limited. At the same time, there are a large number of power electronic devices in the network, and the reactive power injected into the communication system may also pose operational risks to the stability of the communication system. This article mainly proposes a control strategy to reduce the reactive power exchange in the AC/DC system in the case of a large dead zone of reactive power under low power in the Matiari-Lahore DC project. By comparing the reactive power exchange during the lifting process and the number of switching times, the possible applicable solutions and risk points of the current DC transmission system are analyzed, providing feasible solutions for the safe and stable operation of DC transmission projects in the future new power grid.

Simulation Research on Switching Process of Reactive Power Equipment in DC Converter Station

Simulation Research on a Novel Rectifier and Its Control Strategies with Functions of Reactive Power Compensation and Harmonic Current Filtering

Optimal reactive power flow model for AC/DC hybrid power grid with voltage source converters

Analyses of Static and Dynamic Reactive Power Allocation Between Synchronous Compensators and Shunt Capacitors to Counter Commutation Failures

Impedance-based Analysis of Constant Reactive Power Control for Voltage Source Converter in Weak AC Grids

LCC-HVDC System Dynamic Phasor Modeling Based on Improved Switch Function

An Optimal Reactive Power Control Scheme for Rectifying Station Considering the Coordination Control of Low‐voltage Reactor and AC System

Simulation Research on Operation Characteristics of AC Energy Consuming Device in VSC-HVDC System

Dynamic Phasor Model of Line Commutated Converter Under Unbalanced Conditions

Research on Reactive Power Optimization of Synchronous Condensers in HVDC Transmission Based on Reactive Power Conversion Factor

An Optimal Reactive Power Control Scheme for Rectifier Station of LCC-HVDC System During High Power Transmission

Optimal Placement of Dynamic Reactive Power Compensation Devices for Improving Immunity to Commutation Failure in Multi-Infeed HVDC Systems

Simulation of HVDC System Steady and Transient Response by an Analytical Method

Research on Optimal Allocation of Reactive Power Compensators in Substation

Modeling and Simulation for a Hybrid Current Source Converter High Voltage Direct Current Transmission System

Simulation and Experiment on Discharge Characteristics of Indoor Devices in ±1100 Kv Converter Station Based on Potential Gradient Equivalent Method

Research on Control Strategy of DC Distribution Grid with Balanced Load Ratio Between Connected AC Zones

Simulation Research on Solutions to 66kv Vertical SVC Switching Overvoltage and the Implementation

Research on Model Predictive Control Strategy of Converter in Building DC Power Supply System

Research on HVDC Subsequent Commutation Failure Suppression Strategy Considering Energy Storage Phase Modulation Operation

Research on Control Strategy for Reducing Reactive Power Exchange in ACDC Systems under Low Power in DC Engineering