Abstract:Graphene is a useful saturable absorber in a variety of lasers working in mode-locking or Q-switch regimes. The optical performance of chemically synthesized graphene is still not completely characterized. In this study, the saturable absorption and the nonlinear refractive index of graphene flakes in N-methylpyrrolidone, in both liquid and solid phases, have been studied at 800 nm with the z-scan technique using femtosecond laser pulses. The results obtained using a Ti:sapphire laser oscillator in the mode-locking regime (6 fs, 78 MHz) or in the continuous wave shows that the optical properties of graphene have a thermal origin, while at the lower repetition rate and higher energy and intensity of a Ti:sapphire amplifier (95 fs, 1 kHz), it shows the electronic Kerr effect. Solid samples with very high optical densities, equivalent to 60 layers of graphene grown by chemical vapor deposition (CVD), can be fabricated. They show a higher saturation intensity ( I s ≈ 100 GW cm–2) than CVD-grown (74 MW cm–2) or epitaxially grown (4 GW cm–2) graphene and intensity-dependent changes in transmission from 25% to 43%. This change in transmission in multilayer solid samples points to a good performance as a saturable absorber in laser cavities.Graphene is a useful saturable absorber in a variety of lasers working in mode-locking or Q-switch regimes. The optical performance of chemically synthesized graphene is still not completely characterized. In this study, the saturable absorption and the nonlinear refractive index of graphene flakes in N-methylpyrrolidone, in both liquid and solid phases, have been studied at 800 nm with the z-scan technique using femtosecond laser pulses. The results obtained using a Ti:sapphire laser oscillator in the mode-locking regime (6 fs, 78 MHz) or in the continuous wave shows that the optical properties of graphene have a thermal origin, while at the lower repetition rate and higher energy and intensity of a Ti:sapphire amplifier (95 fs, 1 kHz), it shows the electronic Kerr effect. Solid samples with very high optical densities, equivalent to 60 layers of graphene grown by chemical vapor deposition (CVD), can be fabricated. They show a higher saturation intensity ( I s ≈ 100 GW cm–2) than CVD-grown (74 MW cm–2...

Study of a Graphene Saturable Absorber Film Fabricated by the Optical Deposition Method

Graphene-clad Microfibre Saturable Absorber for Ultrafast Fibre Lasers.

Graphene decorated microfiber for ultrafast optical modulation.

Active Graphene-Microfiber Modulator

Graphene-Doped Polymer Optical Nanofibers

Active Control of Absorption in a Hybrid Graphene-Microfiber Modulator

Effective transfer of micron-size graphene to microfibers for photonic applications

Ultrafast All-Optical Graphene Modulator.

Monolayer Graphene as Saturable Absorber in Mode-locked Laser

Atomic layer graphene as saturable absorber for ultrafast pulsed lasers

Low-loss flake-graphene saturable absorber mirror for laser mode-locking at sub-200-fs pulse duration

Saturable Absorption in Graphene-on-waveguide Devices

Pulse-Width Tuning in a Passively Mode-Locked Fiber Laser With Graphene Saturable Absorber

Ultraflat Langmuir–Blodgett assembled graphene oxide saturable-absorber films for pulsed near-infrared laser generation

A photonic crystal-based broadband graphene saturable absorber

Nonlinear thermal and electronic optical properties of graphene in N-methylpyrrolidone at 800 nm with femtosecond laser pulses

Novel nanomaterials based saturable absorbers for passive mode locked fiber laser at 1.5 μm

Novel nanomaterials based saturable absorbers for passive mode locked fiber laser at 1.5 μ m

Broadband Gamma-Graphyne Saturable Absorber for Q-switched Solid-State Laser

Short-pulsed Q-switched fiber laser using graphene oxide quantum dots based as saturable absorber

Fabrication, Characterization and Mode Locking Application of Single-Walled Carbon Nanotube/polymer Composite Saturable Absorbers