Abstract:Functional electrical stimulation (FES) device has been widely used by spinal cord injury (SCI) patients in their rehab exercises to restore motor function to their paralysed muscles. The major challenge of muscle contraction induced by FES is early muscle fatigue due to the open-loop stimulation strategy. To reduce the early muscle fatigue phenomenon, a closed-loop FES system is proposed to track the angle of the limb’s movement and provide an accurate amount of charge according to the desired reference angle. Among the existing feedback controllers, fuzzy logic controller (FLC) has been found to exhibit good control performance in handling complex non-linear systems without developing any complex mathematical model. Recently, there has been considerable interest in the implementation of FLC in hardware embedded systems. Therefore, in this paper, a digital fuzzy feedback controller (FFC) embedded in a field-programmable gate array (FPGA) board was proposed. The digital FFC mainly consists of an analog-to-digital converter (ADC) Data Acquisition and FLC sub-modules. The FFC was designed to monitor and control the progress of knee extension movement by regulating the stimulus pulse width duration to meet the target angle. The knee is expected to extend to a maximum reference angle setting (70°, 40° or 30°) from its normal position of 0° once the stimulus charge is applied to the muscle by the FES device. Initially, the FLC was modelled using MATLAB Simulink. Then, the FLC was hardcoded into digital logic using hardware description language (HDL) Verilog codes. Thereafter, the performance of the digital FLC was tested with a knee extension model using the HDL co-simulation technique in MATLAB Simulink. Finally, for real-time verification, the designed digital FFC was downloaded to the Intel FPGA (DE2-115) board. The digital FFC utilized only 4% of the total FPGA (Cyclone IV E) logic elements (LEs) and required 238 μs to regulate stimulus pulse width data, including 3 μs for the FLC computation. The high processing speed of the digital FFC enables the stimulus pulse width duration to be updated every stimulation cycle. Furthermore, the implemented digital FFC has demonstrated good control performance in accurately controlling the stimulus pulse width duration to reach the desired reference angle with very small overshoot (1.4°) and steady-state error (0.4°). These promising results are very useful for a real-world closed-loop FES application.

A Real-Time Virtual Manipulator Simulation Platform Based on FPGA

A High Performance FPGA-based Joint Controller with Hardware/software Co-Design Method

A Real-Time Dynamic Simulation Platform for 6R Manipulators Based on an Explicit Modeling Method

Virtual bionic hand co-simulation systems and fuzzy servo control algorithm

Dynamic Modeling and Real-time Simulation of Soft Manipulator

DSP/FPGA-based Controller Architecture for Flexible Joint Robot with Enhanced Impedance Performance

Haptic virtual surgery simulation system under field programmable analogue array-based hybrid control

FPGA-implementation of passivity-based control for elastic-joint robot

High dynamic humanoid robot arm for ping-pong playing

Flexible FPGA-based Controller Architecture for Five-Fingered Dexterous Robot Hand with Effective Impedance Control

Design of prosthetic hand control system based on FPGA

Design and Control of a Low-cost Non-backdrivable End-effector Upper Limb Rehabilitation Device

Real-time Simulation and Research of Motor Controller Based on FPGA

Semi-Physical Realtime Simulation of Virtual Asynchronous Motor Based on FPGA

Design of a Multi-Degree-of-freedom Virtual Hand Bench for Myoelectrical Prosthesis

Co-simulation and control algorithm of intelligent bionic hands with multi-degree of freedom

Design of an FPGA-Based Fuzzy Feedback Controller for Closed-Loop FES in Knee Joint Model

Adaptive Biological Neural Network Control and Virtual Realization for Engineering Manipulator

The Control System of Exoskeleton Hand for EVA Glove Mechanics Testing Based on FPGA

FPGA-in-the-Loop for Control Emulation of Distributed MEMS Simulation Using VHDL-AMS

Virtual liver surgery simulation system supporting haptic feedback