Abstract:Water molecules lose electrons (which are oxidized) to form oxygen gas (O2), along with hydrogen ions (H+) and electrons. 2H2O→O2 +4H++4e−: Hydrogen ions (H+) gain electrons (which are reduced) to form hydrogen gas (H2). 4H++4e−→2H2: Together, these reactions split water into oxygen and hydrogen, with electrons transferred from the anode to the cathode. Hydrogen and renewable fuels were generated using cost‐effective and efficient electrocatalysts for water splitting. In this work, a CuO‐based photocathode is used for the water splitting to generate hydrogen energy by PVD technique. The XRD analysis reveals the deposition of CuO thin film on ITO substrates, which is monoclinic. The XRD and LSV analysis of CuO confirmed the type of semiconductor and observed to be P‐type semiconductor. SEM study of CuO confirmed the shape, morphology to be a circular and regular shape. The grain size of deposited CuO thin film was found to be 18 nm. The absorption and transmission of CuO thin film were observed through UV spectroscopy analysis and were found to be better photocatalyst in visible range 415–425 nm. The transmittance of the prepared thin film was noted to be maximum 7.6% in the UV range (280–300 nm). The band gap was also measured employing the Tauc plot and found to be 2.98 eV, which is most favorable for water splitting application. FTIR study showed the stretching, vibration, and the functional group of the deposited CuO thin film; the broad band of stretching of Cu‐O in monoclinic CuO was observed at the range of 500–700 cm−1, and further peaks were also noted at the range of 1500–1600 cm−1. The linear sweep voltammetry (LSV) of CuO thin film was calculated in the absence of solar spectra and the presence of solar spectra and observed to be enhanced in current under solar spectra. The solar light to hydrogen emission percentage (STH %) of CuO through LSV was observed to be 2.04% under solar spectra. The low Nyquist curve of blank ITO and CuO‐coated ITO substrate via electrochemical impedance spectroscopy (EIS) analysis was observed, which confirmed the enhancement of EIS of CuO‐coated ITO. The hydrogen generation rate was also calculated by electrochemical cell and observed to be 5325.21 mol g−1 for 6 h.

Synthesis of Semimetallic Tungsten Trioxide for Infrared Light Photoelectrocatalytic Water Splitting

Theoretical Study of Oxygen Vacancy on Indium Oxide for Promoted Photothermal Catalytic Water Splitting

Tungsten oxide nanostructures and nanocomposites for photoelectrochemical water splitting

Electrochemical synthesis and characterization of tungsten oxide catalysts for photoelectrochemical water splitting

Elucidating the electronic structure of CuWO4 thin films for enhanced photoelectrochemical water splitting

Tungsten Trioxide Nanostructures for Solar Energy Conversion

Composites Based on Electrodeposited WO3 and TiO2 Nanoparticles for Photoelectrochemical Water Splitting

Balancing Catalytic Activity and Interface Energetics of Electrocatalyst-Coated Photoanodes for Photoelectrochemical Water Splitting.

High-Voltage Etching-Induced Terrace-like WO 3 Photoanode for Efficient Photoelectrochemical Water Splitting

Facile Fabrication of Sandwich Structured WO3 Nanoplate Arrays for Efficient Photoelectrochemical Water Splitting.

Facile preparation of platelike tungsten oxide thin film electrodes with high photoelectrode activity.

One-Step Rapid and Scalable Flame Synthesis of Efficient WO3 Photoanodes for Water Splitting.

Tungsten induced defects control on BiVO4 photoanodes for enhanced solar water splitting performance and photocorrosion resistance

Facile synthesis of CoO x @C/Ti-Fe 2 O 3 photoanodes for efficient photoelectrochemical water oxidation

Investigation of CuO/ITO Photoelectrode Fabricated by PVD for Efficient Photoelectrochemical Water Splitting and Hydrogen Evolution

Direct Water Splitting into H2 and O2 under Visible Light Irradiation with a New Series of Mixed Oxide Semiconductor Photocatalysts

Distinguished Heterojunction and Co-Catalyst Behaviors on Tungsten Doped BiVO4 for Photoelectrochemical Catalytic Water Splitting Reaction

Regulating the Binding Strength of Oxygen Intermediates with a Conductive Π–d Conjugated Metal-Organic Polymer CoTAA on BiVO4 Photoanode for Efficient Photoelectrochemical Water Oxidation

Photoelectrochemical Properties and Behavior of α-SnWO4 Photoanodes Synthesized by Hydrothermal Conversion of WO3 Films

3D Cathodes of Cupric Oxide Nanosheets Coated onto Macroporous Antimony-Doped Tin Oxide for Photoelectrochemical Water Splitting

A P-N WO3/SnSe2 Heterojunction for Efficient Photo-assisted Electrocatalysis of the Oxygen Evolution Reaction