Abstract:Synthetic aperture radar interferometry (InSAR) has been widely used over the past two decades for such geodetic applications as topographic mapping and ground deformation monitoring. In particular, in contrast to other geodetic techniques, differential InSAR has the capability of measuring surface deformation with a measurement precision of a few millimetres and a spatial resolution of a few tens of metres or less, over areal extents of thousands of square kilometers.However, the ground surface may deform by a large amount within a small area due to localised effects such as earthquakes, underground mining, groundwater extraction, and others, which may cause severe damage to manmade surface and underground structures. Current satellite radar interferometry, because of its single-frequency signal structure, cannot measure deformations with large horizontal gradients as they produce very dense fringe patterns. The upper limit of the deformation gradient is determined by the signal wavelength and pixel spacing. Although the longer wavelength of the radar signal is less susceptible to high deformation gradients, loss of correlation often still occurs even when L-band imagery is used.In this paper, the authors propose a method to effectively monitor such large-gradient deformation using differential InSAR by linear combinations of interferograms acquired from dual-frequency sensors. Some simulated interferograms are generated through the combination of the commonly used radar wavelengths, for instance C, L(1), L(2), S and even P-band. Using appropriate linear combinations, the virtual wavelength of the combined interferogram is flexible enough to be used for different applications. From the simulated results, it is found that the linear combination technique is powerful and can improve the correlation, as well as making the phase unwrapping process much easier.

Ground-based Deformation Measurement Radar Configured with Multiple-Input Multiple-Output Antennas

3-D High-Resolution Imaging and Array Calibration of Ground-Based Millimeter-Wave MIMO Radar

Millimeter-wave MIMO imaging radar with an ultra-high angular resolution of 0.6 degree

3-D Deformation Measurement Based on Three GB-MIMO Radar Systems: Experimental Verification and Accuracy Analysis

Mass Production Development of 4D Millimeter-Wave Radar Based on a Single Chip

3D Imaging for 77 GHz MIMO-SAR

Inflatable Antenna for Earth Observing Systems

3-D Motion Imaging in a Multipath Coordinate Space Based on a TDM-MIMO Radar Sensor

Advanced Ground-Based Real and Synthetic Aperture Radar

Dynamic Deformation Measurement of Bridge Structure Based on GB-MIMO Radar

Linear Combinations For Differential Radar Interferometry

Integrated Ground-Based SAR Interferometry, Terrestrial Laser Scanner, and Corner Reflector Deformation Experiments

Applications and validation tests of ground-based coherent radar for deformation and vibration measurements in Canada's Atlantic region

MIMO Radar and Ground-Based SAR Imaging Systems: Equivalent Approaches for Remote Sensing

Real-time Profile Measurement Method for a Large-Scale Satellite Antenna

Calibration of Polarimetric Millimeter MIMO Radar for Near-Field Ultrawideband Imaging Measurement

MIMO-SAR Interferometric Measurements for Structural Monitoring: Accuracy and Limitations

Fast and Accurate Full-field Out-of-plane Displacement Measurement Using MIMO-SAR-Based Microwave Interferometry

Multi-Monostatic Interferometric Radar for Bridge Monitoring

A Three-Dimensional Deformation Monitoring Method: Combining Optical Deformation Monitoring Based on Regression Models and GB-SAR Interferometry

SPARX, a MIMO Array for Ground-Based Radar Interferometry