Preparation of Isolate Protein from Selenium-enriched Peanut
Lin Gao,Wenting Zhao,Xia Tian,Ruifang Mi,Xiaosong Hu,Jihong Wu
DOI: https://doi.org/10.16429/j.1009-7848.2017.10.015
2017-01-01
Abstract:Selenium is an essential micronutrient required at trace levels for human health,which is often supplied by natural plants or animals to humans at levels too low for optimum health.In recent years,there has been growing interest in producing selenium-enriched agricultural products,such as selenium-enriched peanut,selenium-rich rice,selenium-enriched apple,etc.Selenium-enriched peanut,a kind of selenium-enriched agricultural products,for example,planted widely in ecological agricultural base,like Enshi of Hubei,Ziyang county of Shaanxi province,Fengcheng of Jiangxi.However,the concentration of the industry is not high,and products are mostly low value-added primary ones.For developing high value-added production of selenium-enriched products,the process optimization was necessary.In the paper,with selenium-enriched peanut (0.25 ± 0.05) mg Se/kg peanut as raw material,the isolate protein was prepared by using high hydrostatic pressure assisted extraction technology for removing selenium-enriched peanut oil,and alkaline extraction and acid precipitation method for protein extraction,meanwhile the content of selenium was tracing analyzed.Results showed that during the lipid extraction process assisted with high hydrostatic pressure of 300 MPa and 5 min,combined with water bath in 40 ℃ extracting 6 h,peanut oil could be removed efficiently.The treatment of 300MPa high hydrostatic pressures could not only greatly shorten the process time,but also make emulsification property and emulsification stability achieve better.While isolate protein extracting,the effect of the extracting solution pH,extraction time,extraction temperature,solid-to-liquid ratio and the acid precipitator pH on the extraction yield of protein were conducted using single factor experiment respectively.On this basis,50 ℃ of extraction temperature and 5.5 of the acid precipitator pH was obtained,then the optimal factors including the extracting solution pH (X1),extraction time (X2),solid-to-liquid ratio (X3) were investigated by Box-Behnken surface response design method.The quadratic multiple regression equation was established as Y (％) =86.30+ 1.19X1+ 1.77X2+0.47X3+0.22X1X2-0.53X1X3+0.55X2X3-2.09X12-1.48X22-0.87X32,while the optimum conditions for the protein extraction were obtained by the regression equations:9.1 for the extracting solution pH,97 min of extraction time,1∶11 g/mL of solid-to-liquid ratio,and under which optimum conditions,the yields of protein could be reached 86.92％ ± 0.17％.Thus optimum technology can reduce the extraction time and improve the efficiency of extraction significantly.At last,the change of Se content in various process stages was determined by ICP-MS.It indicated that selenium existed mainly in deoiled peanut,and the average value of total selenium content of isolate protein by optimized way could be reached to 0.37 mg/kg,among which about 0.35 mg/kg was organic selenium,representing 95％ of the total selenium.In general,selenium-enriched isolate protein was a kind of high value-added production of selenium-enriched peanut,and had good application prospects.