Abstract:With the emerging need for human-machine interactions, multi-modal sensory interaction is gradually pursued rather than satisfying common perception forms (visual or auditory), so developing flexible, adaptive, and stiffness-variable force-sensing devices is the key to further promoting human-machine fusion. However, current sensor sensitivity is fixed and nonadjustable after fabrication, limiting further development. To solve this problem, we propose an origami-inspired structure to achieve multiple degrees of freedom (DoFs) motions with variable stiffness for force-sensing, which combines the ductility and flexibility of origami structures. In combination with the pneumatic actuation, the structure can achieve and adapt the compression, pitch, roll, diagonal, and array motions (five motion modes), which significantly increase the force adaptability and sensing diversity. To achieve closed-loop control and avoid excessive gas injection, the ultra-flexible microfiber sensor is designed and seamlessly embedded with an approximately linear sensitivity of ∼0.35 Ω/kPa at a relative pressure of 0-100 kPa, and an exponential sensitivity at a relative pressure of 100-350 kPa, which can render this device capable of working under various conditions. The final calibration experiment demonstrates that the pre-pressure value can affect the sensor's sensitivity. With the increasing pre-pressure of 65-95 kPa, the average sensitivity curve shifts rightwards around 9 N intervals, which highly increases the force-sensing capability towards the range of 0-2 N. When the pre-pressure is at the relatively extreme air pressure of 100 kPa, the force sensitivity value is around 11.6 Ω/N. Therefore, our proposed design (which has a low fabrication cost, high integration level, and a suitable sensing range) shows great potential for applications in flexible force-sensing development.

Handwriting Iontronic Pressure Sensing Origami.

Pencil-on-paper Strain Sensor for Flexible Vertical Interconnection

Hand-drawn Variable Resistor and Strain Sensor on Paper

Ionogel Infiltrated Paper As Flexible Electrode for Wearable All-Paper Based Sensors in Active and Passive Modes

Bamboo-Inspired, Environmental Friendly PDMS/Plant Fiber Composites-Based Capacitive Flexible Pressure Sensors by Origami for Human–Machine Interaction

Rapid Fabrication of Haptic and Electric Input Interfaces Using 4D Printed Origami

Flexible Capacitive Three-Dimensional Force Sensor for Hand Motion Capture and Handwriting Recognition

One-Step Process of Wrinkle Microstructured Iontronic Pressure Sensor with All Fabric Wearable Electrode

Anaphylactoid reaction to etomidate: report of a case.

Origami-Inspired Structure with Pneumatic-Induced Variable Stiffness for Multi-DOF Force-Sensing

Paper-Based Sensor with Bioinspired Macrogrooves for Dual Pressure and Mechanical Strain Signal Detection

Highly Sensitive Paper-Based Force Sensors with Natural Micro-Nanostructure Sensitive Element

Superhydrophobic, stretchable kirigami pencil-on-paper multifunctional device platform

Highly Sensitive and Wide Linear-Response Pressure Sensors Featuring Zero Standby Power Consumption under Bending Conditions

Electromechanical performance of flexible sensor based on 3D printed biomimetic all-PDMS-coated multistage structure: toward kinesiology monitoring and human-machine interaction

Facilely constructed two-sided microstructure interfaces between electrodes and cellulose paper active layer: eco-friendly, low-cost and high-performance piezoresistive sensor

An ultra-sensitive and wide measuring range pressure sensor with paper-based CNT film/interdigitated structure

Ultralow-Cost, Highly Sensitive, and Flexible Pressure Sensors Based on Carbon Black and Airlaid Paper for Wearable Electronics

A Flexible Resistive Pressure Sensor Based On Thermally Expandable Microspheres

A lightweight, ultrathin aramid-based flexible sensor using a combined inkjet printing and buckling strategy

Highly Sensitive and Flexible Capacitive Pressure Sensor Based on a Dual-Structured Nanofiber Membrane as the Dielectric for Attachable Wearable Electronics