Abstract:This study focuses on a green synthesis of Cu2O and Cu2O−Ag particles using ascorbic acid (LAA) as a reducing agent in the presence of two surfactants, polyethylene glycol 6000 and sodium dodecyl sulfate. The hybrid materials exhibit strongly antibacterial activity and are potential for the application in the acrylic emulsion coating. Nanomaterials based on metal oxides, especially Cu2O, have received much attention in recent years due to the many unique properties of the surface plasmon resonance they provide. The report presented the co‐precipitation method, a simple preparation method to produce Cu2O oxide particles. In addition, to improve the unique antibacterial properties of Cu2O, a proposed method is to attach Ag nanoparticles to the surface of Cu2O particles. The Cu2O and Cu2O−Ag particles were synthesized based on redox reactions using ascorbic acid (LAA) as a reducing agent. Moreover, in this experiment, two surfactants, polyethylene glycol 6000 (PEG 6000) and sodium dodecyl sulfate (SDS), were added during the manufacturing process to create particle samples and particle combinations with better properties than the original sample. Changes in the characteristics and properties of particle samples are determined by many different physical and chemical methods such as ultraviolet‐visible spectroscopy (UV‐Vis), infrared spectroscopy (IR), noise X‐ray radiation (XRD), scanning electron microscope (SEM), dynamic light scattering (DLS), energy dispersive X‐ray spectroscopy (EDS), and transmission electron microscopy (TEM). Finally, the activity against bacteria, including E. coli and S. aureus, was also tested using the agar well diffusion method to determine the zone of inhibition. The results improved the particle size value, which decreased by half to 200 nm when two additional surfactants, PEG and SDS, were added. In addition, the antibacterial ability has also been shown to increase significantly when the diameter of the bacterial inhibition zone increased significantly, reaching values of 20 mm (Cu2O/Ag/SDS) and 32 mm (Cu2O/Ag/PEG) for the E. coli bacterial strain. The initial test sample was only about 14 mm in size. The S. aureus bacterial strain also had a similar improvement trend after adding Ag to the Cu2O surface with the appearance of two surfactants, SDS and PEG. The inhibition zone diameter values reached the optimal value at 36 mm in the Cu2O/Ag/PEG particle combination sample compared to only the initial 26 mm in the Cu2O particle sample. Finally, the particle samples are added to the acrylic emulsion paint film to evaluate the changes. Positive results were obtained, such as improvement in adhesion (1.22 MPa), relative hardness (240/425), and sand drop resistance (100 L/mil) in the Cu2O/Ag/PEG particle combination sample, which showed the correctness and accuracy of the research.

Interfacial interaction of Cu–Ag nanoparticles with different surfactants

Molecular dynamics study of the effect of inorganic salts on the monolayer of four surfactants at the oil/water interface

Study Interactions Between Inhaled Nanoparticles and Pulmonary Surfactant Using Molecular Dynamics Simulations

Computational Investigations of the Interaction Between the Cell Membrane and Nanoparticles Coated with a Pulmonary Surfactant.

Molecular dynamics study of nanoparticles and non-ionic surfactant at an oil–water interface

Molecular Dynamics Simulation of the Effects of Complex Surfactants on Oil-Water Interaction and Aggregation Characteristics at the Interface.

Interfacial surfactant competition and its impact on poly(ethylene oxide)/Au and poly(ethylene oxide)/Ag nanocomposite properties

Transformation of CuO Nanoparticles in the Aquatic Environment: Influence of Ph, Electrolytes and Natural Organic Matter

Self-assembly of nanoparticles and surfactant molecules at the gas-liquid interface

Evaluation of Interfacial Structure of Self-Assembled Nanoparticle Layers: Use of Standard Deviation between Calculated and Experimental Drop Profiles as a Novel Method

Surfactant induced smooth and symmetric interfaces in Cu/Co multilayers

Aqueous-organic phase transfer of nanoparticles: The effects of molecular structures of cationic surfactants

In Situ Assay of Interfacial Interaction Between ZnO Nanoparticles and Live Cell Disturbed by Surfactants.

Molecular Dynamics Simulation of the Coalescence and Melting Process of Cu and Ag Nanoparticles

Effect of the Surface Charge Density of Nanoparticles on Their Translocation Across Pulmonary Surfactant Monolayer: a Molecular Dynamics Simulation

Effect of Co‐Surfactants on Properties and Bactericidal Activity of Cu2O and Hybrid Cu2O/Ag Particles

Molecular dynamics simulation and experimental study on the effect of surfactants on the compatibility of P(S-DVB)-SO4/CeO2 composite interface

Surfactant adsorption and aggregate structure of silica nanoparticles: a versatile stratagem for the regulation of particle size and surface modification

Effects of catanionic surfactant mixture adsorption on the wettability of PTFE and PMMA

Surfactants Present Complex Joint Effects on the Toxicities of Metal Oxide Nanoparticles.

Investigation of the interfacial phenomena in the presence of nonionic surfactants and a silica nanoparticle at the n-decane-water interface: Insights from molecular dynamics simulation