Abstract:The steam-water separator is vitally important equipment to remove the droplets entrained by the vapor stream to provide dry saturated steam for the steam turbine in the nuclear power station. With the development of the large nuclear power station and the vessel nuclear power plant, the steam-water separation performance should be more efficient under the condition of higher pressure, power load and circulating ratio. The droplet motion model, which is solved by typical four steps Runge-Kutta method and validated against the experimental results, is developed according to the physical phenomenon description and the mechanism comprehension of the vapor entrained droplets moving in the wave-type vanes separator. The Euler-Lagrange methodology is adopted to simulate the moving droplet entrained by the vapor stream in the wave-type vanes separator and the separation performance is investigated. The separation efficiency of the separator and motion trajectories of droplets with various sizes are presented. Stokes Number (St) of diverse droplets is obtained to analyze the influence of Stokes Number on the moving droplets trajectories and the separation efficiency. The results reveal that the values of Stokes Number for most of the moving droplets in the wave-type vanes separator are beyond 1, which indicates that most of droplets are likely to collide with the solid wall of the separator. Only when the droplet velocity is smaller than 1 m/s or the droplet radius is less than 2 μm, the Stokes Number may be below 1 and the moving droplets can be entrained by the stream flow until escaping from the separator. The analysis can forecast the maximum critical separation size of the droplets that cannot be removed, and the minimum critical separation size of the droplets that can be removed throughly by the separator and guide the design of the separator.

Numerical investigation on performance of moisture separator by Lagrangian-Eulerian strategy: Physical mechanisms, theoretical models, and advanced algorithms

Numerical Investigation on Performance of Moisture Separator: Experimental Validation, Applications and New Findings

Numerical Investigation on Droplet Collision Phenomena in Moisture Separators Using Population Balance Model under Lagrangian Framework

Study on Working Mechanism of AP1000 Moisture Separator by Numerical Modeling

Study Of The Numerical Solving Methods Of The Motion Model Of Polydispersed Droplets

Numerical investigation of the performance of moisture separators based on two-way coupling model by Lagrangian-Eulerian methodology

Numerical Investigation of Moisture Separators with Corrugated Plates

Numerical study on momentum transfer between droplets and carrier phase in wave type plate separators

Numerical Investigation of the Separation Performance of Full-Scale AP1000 Steam-Water Separator

Stokes Number Analysis of the Moving Droplets in the Steam-Water Separator

Numerical Prediction of the Outcomes of Binary-Droplet Collision in Steam-Water Separator

Three-dimensional Euler Grid Approximation Method for Multi-Droplet Motions in the Steam-Water Separator

Study of Droplets Behaviors in the Steam-Water Separator with Monte Carlo Method

Droplet Phase Change Model and Its Application in Wave-Type Vanes of Steam Generator

Study on Separation Ability and Structure Optimization of AP 1000 Wave-type Plate Steam-water Separator Based on Droplet Collision Model

Influence of Secondary Droplet on Separation Performance of Wave-Type Vane Separator

Numerical Simulation Of Spray Evaporation Characteristics In Desulfuerization Reactor

Static Droplet Phase Transformation Model for Variable Pressure Conditions

Full-scale Numerical Study on the Flow Characteristics and Mal-Distribution Phenomena in SG Steam-Water Separation System of an Advanced PWR

Modeling Droplet-Laden Flows in Moisture Separators Using K- D Trees

Visual experimental study of droplet impinging on liquid film and analysis of droplet evolution characteristics